CCNA Exam Quizzes & Trivia

Recently Updated

Examen Final CCNA Quiz! Trivia

Questions: 50 | Attempts: 109 | Last updated: Nov 5, 2020

Sample Question
Cuándo se usará la palabra clave multipoint en la configuración de PVC de Frame Relay?

Cuando se estén usando DLCI globales

Cuando se usen interfaces físicas

Cuando puedan admitirse multicasts

Cuando los routers participantes estén en la misma subred

CCNA #10!!

CCNA #10CCNA #10

Questions: 17 | Attempts: 108 | Last updated: Jul 30, 2011

Sample Question
When are link-state packets sent to neighbors?

Every 30 seconds

Every 180 seconds

After the holddown time expires

When a link goes up or down

When a routing loop occurs

Ccna3 Final All April 2013

ccna3 final all april 2013

Ccna3 final all april 2013

Questions: 184 | Attempts: 108 | Last updated: Apr 25, 2013

Sample Question
Refer to the exhibit. After entering the commands in the exhibit, the administrator receives a “password required, but none set” message when attempting to connect to S1. What is the problem?

The enable secret password was not set.

S1 does not have login configured on the vty lines.

S1 does not have a password configured for the vty lines.

The crypto key is not properly configured to generate passwords.

The VLAN1 interface has not be enabled with the no shutdown command.

The Candid Test On CCNA Chapter 6

The candid test on CCNA Chapter 6

Welcome to the candid test on CCNA Chapter 6, where we will be discussing the wide range of topics discussed in the sixth chapter of your studies regarding the CCNA certification. Can you answer all of the questions provided...

Questions: 21 | Attempts: 108 | Last updated: Nov 29, 2018

Sample Question
Given the IP address and subnet mask of 172.16.134.64 255.255.255.224, which of the following would describe this address?

This is a useable host address

This is a broadcast address

This is a network address

This is not a valid address

CCNA 2 (A)

PRACTICING FOR CNNA2 ONLINE FINAL

Questions: 57 | Attempts: 108 | Last updated: Jan 15, 2013

Sample Question
Refer to the exhibit. The network administrator issues the command no ip classless on Router1. What forwarding action will take place on a packet that is received by Router1 and is destined for host 192.168.0.26?

The packet will be dropped

The packet will be forwarded to the gateway of last resort.

The packet will match the 192.168.0.0 network and be forwarded out Serial 0/0.

The packet will most closely match the 192.168.0.8 subnet and be forwarded out Serial 0/1.

OSI Network Layer Chapter 5

Questions: 21 | Attempts: 103 | Last updated: Feb 23, 2018

Sample Question
Refer to the exhibit. Using the network in the exhibit, what would be the default gateway address for host A in the 192.133.219.0 network?

192.135.250.1

192.31.7.1

192.133.219.0

192.133.219.1

CCNA Final Exam 1

CCNA final exam 1

1. TesTs gi gi gi

Questions: 50 | Attempts: 102 | Last updated: Mar 7, 2013

Sample Question
Which of the following are the address ranges of the private IP addresses? (Choose three.)

10.0.0.0 to 10.255.255.255

200.100.50.0 to 200.100.25.255

150.150.0.0 to 150.150.255.255

172.16.0.0 to 172.31.255.255

192.168.0.0 to 192.168.255.255

127.16.0.0 to 127.31.255.255

Ccna_1_finals_example_1

CCNA_1_FINALS_Example_1

1/4

Questions: 50 | Attempts: 97 | Last updated: Jan 12, 2013

Sample Question
When must a router serial interface be configured with the clock rate command?

When the interface is functioning as a DTE device

when the interface timers have been cleared

when the connected DTE device is shut down

when the interface is functioning as a DCE device

This Quiz On CCNA Is Only For Geniuses 2

This Quiz on CCNA is only for geniuses 2

The CCNA aren’t for everyone and this is why not everyone gets to achieve that certification and is left behind to sit for the next quiz. If you believe you are a genius when it comes to CCNA exams? Take this unbeatable...

Questions: 22 | Attempts: 96 | Last updated: Nov 29, 2018

Sample Question
A static route that points to the next hop IP will have what administrative distance and metric in the routing table?

Administrative distance of 0 and metric of 0

Administrative distance of 0 and metric of 1

Administrative distance of 1 and metric of 0

Administrative distance of 1 and metric of 1

CCNA 2 Final Exam

CCNA 2 final exam

Questions: 74 | Attempts: 96 | Last updated: Jan 30, 2013

Sample Question
Refer to the exhibit. Given the topology shown in the exhibit, what three commands are needed to configure EIGRP on the Paris router? (Choose three.)

Paris(config)# router eigrp 100

Paris(config)# router eigrp

Paris(config-router)# network 192.168.6.0

Paris(config-router)# network 192.168.7.0

Paris(config-router)# network 192.168.8.0

Paris(config-router)# network 192.168.9.0

CCNA 6 And 10

ccna 6 and 10

I love it to cool for skool

Questions: 18 | Attempts: 95 | Last updated: Jan 7, 2013

Sample Question
Refer to the exhibit. The network administrator wants to minimize the number of entries in Router1’s routing table. What should the administrator implement on the network?

VLSM

CIDR

Private IP addresses

Classful routing

CCNA Chapter 1

ccna chapter 1

Loving it the best mate

Questions: 16 | Attempts: 94 | Last updated: Jan 3, 2013

Sample Question
The Network administrator needs to connect two routers directly via their FastEthernet ports.What cable should the network administrator use?

Straight through

Rollover

Cross over

Serial

CCNA Protocol Practice Quiz

CCNA protocol practice quiz

Questions: 25 | Attempts: 88 | Last updated: May 17, 2018

Sample Question
A company is developing an Internet store for its website. Which protocol should be used to transfer credit card information from customers to the company web server?

FTPS

HTTP

HTTPS

WEP2

TFTP

CCNA Ewan Final Exam

CCNA EWAN Final Exam

Questions: 13 | Attempts: 88 | Last updated: Feb 12, 2013

Sample Question
Refer to the exhibit. Branch A has a non-Cisco router that is using IETF encapsulation and Branch B has a Cisco router. After the commands that are shown are entered, R1 and R2 fail to establish the PVC. The R2 LMI is Cisco, and the R1 LMI is ANSI. The LMI is successfully established at both locations. Why is the PVC failing?

The PVC to R1 must be point-to-point.

LMI types must match on each end of a PVC.

The frame relay PVCs cannot be established between Cisco and non-Cisco routers.

The IETF parameter is missing from the frame-relay map ip 10.10.10.1 201 command.

CCNA 2 (B)

CCNA 2 (B) for final online quiz

Questions: 57 | Attempts: 88 | Last updated: Jan 15, 2013

Sample Question
Refer to the exhibit. The output of the show ip route command for three routers on a network is displayed. All routers are operational, pings are not blocked on this network, and no default routes are installed. Which two pings will fail? (Choose two.)

From R1 to 172.16.1.1

From R1 to 192.168.3.1

From R2 to 192.168.1.1

From R2 to 192.168.3.1

From R3 to 192.168.1.1

Ccna_1_finals_example_2

CCNA_1_FINALS_Example_2

2/4

Questions: 50 | Attempts: 86 | Last updated: Sep 22, 2016

Sample Question
1. When must a router serial interface be configured with the clock rate command?

When the interface is functioning as a DTE device

when the interface timers have been cleared

when the connected DTE device is shut down

when the interface is functioning as a DCE device

Informative Quiz On CCNA 4 Final Exam

Informative Quiz on ccna 4 final exam

Cisco Certified Network Associate is an information technology certification from Cisco. CCNA certification is an associate-level Cisco Career certification. The informative on CCNA 4 final exam below is designed to help you...

Questions: 49 | Attempts: 86 | Last updated: Nov 29, 2018

Sample Question
Refer to the exhibit. The SSH connections between the remote user and the server are failing. The correct configuration of NAT has been verified. What is the most likely cause of the problem?

SSH is unable to pass through NAT.

There are incorrect access control list entries.

The access list has the incorrect port number for SSH.

The ip helper command is required on S0/0/0 to allow inbound connections.

Ccna2 Final Exam 2013 â€“ Version1

CCNA2 Final Exam 2013 â€“ version1

Questions: 50 | Attempts: 85 | Last updated: Nov 16, 2014

Sample Question
Which of the following are required when adding a network to the OSPF routing process configuration? (Choose three)

Network address

Loopback address

Autonomous system number

Subnet mask

Wildcard mask

Area ID

CCNA Quiz-1

Questions: 20 | Attempts: 84 | Last updated: Feb 12, 2013

Sample Question
Which command displays RIP routing updates?

Router#show router rip

Router#debug ip rip

Router#show debug updates

Router# show router updates

CCNA 4 Chapter 4

Questions: 22 | Attempts: 81 | Last updated: Jan 31, 2013

Sample Question
1. Which two statements are true regarding network security? (Choose two.)

Securing a network against internal threats is a lower priority because company employees represent a low security risk.

Both experienced hackers who are capable of writing their own exploit code and inexperienced individuals who download exploits from the Internet pose a serious threat to network security.

Assuming a company locates its web server outside the firewall and has adequate backups of the web server, no further security measures are needed to protect the web server because no harm can come from it being hacked.

Established network operating systems like UNIX and network protocols like TCP/IP can be used with their default settings because they have no inherent security weaknesses.

Protecting network devices from physical damage caused by water or electricity is a necessary part of the security policy.

An Interesting Quiz On CCNA 2 Chapter 10

An interesting quiz on ccna 2 chapter 10

In chapter ten we got to understand how data is moved across the network, from opening an application to receiving data. What else can you remember from CCNA 2 chapter 10? Take up this interesting quiz and know for sure....

Questions: 38 | Attempts: 80 | Last updated: Nov 29, 2018

Sample Question
When are link-state packets sent to neighbors?

Every 30 seconds

Every 180 seconds

After the holddown time expires

When a link goes up or down

When a routing loop occurs

CCNA Chapter 4

ccna chapter 4

The best i love it

Questions: 17 | Attempts: 78 | Last updated: Jan 7, 2013

Sample Question
What metric does the RIP routing protocol consider to be infinity?

0

15

16

224

255

An Interesting Quiz On CCNA Chapter 8

An interesting quiz on ccna chapter 8

The Cisco Certified Network Associate (CCNA) program is here to give you the tools needed to gain an understanding on the inner workings of networking theory, and today we’ll be taking a look at some of the topics...

Questions: 16 | Attempts: 77 | Last updated: Nov 29, 2018

Sample Question
Refer to the exhibit .what protocol was used to distribute the routing information for the network 172.16.1.4?

RIPV1

RIP V2

EIGRP

OSPF

Ccna4 Chapter 3

CCNA4 chapter 3

Questions: 22 | Attempts: 76 | Last updated: Jan 21, 2013

Sample Question
1 Which best describes the benefit of using Frame Relay as opposed to a leased line or ISDN service?

1. Customers can define their virtual circuit needs in far greater combinations, with increments as small as 64 kbps.

2. Customers pay for an end-to-end connection that includes the local loop and the network link.

3. Customers only pay for the local loop and the bandwidth they purchase from the network provider.

4. Connecting new sites requires new lower cost circuit installations when compared to ISDN dialup costs or adding additional hardware for leased service.

CCNA Exploration 4 Final

Here we are, folks, it’s the final exam of the Cisco Certified Network Associate’s Exploration curriculum, and we hope you’ve been keeping your nose in a book because this is a big one! Think you have what it...

Questions: 20 | Attempts: 75 | Last updated: Jan 4, 2019

Sample Question
Which of the following describes the roles of devices in a WAN? (Choose three.)

A CSU/DSU terminates a digital local loop.

A modem terminates a digital local loop

A CSU/DSU terminates an analog local loop.

A modem terminates an analog local loop.

A router is commonly considered a DTE device.

« Previous 1 2 345 6 7 8 9 Next »