CCNA Exam Quizzes & Trivia
Questions: 93 | Attempts: 424 | Last updated: Mar 30, 2013
-
Sample QuestionWhat functionality do access control lists provide in the implementation of dynamic NAT on a Cisco router?
Ccna exploration 4.0 routing protocols and concepts Chapter 4
Questions: 21 | Attempts: 423 | Last updated: Jan 8, 2013
-
Sample QuestionWhat is a routing loop?
Questions: 50 | Attempts: 412 | Last updated: Jun 12, 2013
-
Sample Question1. Which of the following are required when adding a network to the OSPF routing process configuration?
Welcome back to another instalment of our ongoing quiz series on Network Fundamentals, as taught as part of the programme issued by Cisco as part of its Certified Network Associate. Are you able to tell us even more about the...
Questions: 8 | Attempts: 407 | Last updated: Jan 4, 2019
-
Sample QuestionWhat application layer protocol is commonly used to support for file transfers between a client and a server?
There are 30 questions that have to get answered.Get ready for a hard Exam of CCNA Discovery
Questions: 28 | Attempts: 406 | Last updated: Jan 11, 2013
-
Sample QuestionWhich term is used to describe the process of placing one message format into another format so that the message can be delivered across the appropriate medium?
If you are looking for the best CCNA final exam practice quiz then you just got lucky. The quiz below has the questions from the current syllabus. Give it a shot and see if you might need more reading time. All the best of...
Questions: 49 | Attempts: 392 | Last updated: Nov 29, 2018
-
Sample QuestionRefer to the exhibit. The SSH connections between the remote user and the server are failing. The correct configuration of NAT has been verified. What is the most likely cause of the problem?
Questions: 50 | Attempts: 385 | Last updated: Jun 12, 2013
-
Sample Question1. Which of the following are required when adding a network to the OSPF routing process configuration? (Choose three.)
Pense rápido: Responsa estas 5 questões em apenas 2 minutos! Boa sorte!
www.linkstate.com.br
Questions: 5 | Attempts: 383 | Last updated: Sep 12, 2011
-
Sample QuestionQual bit no Frame Relay, quando ativado, indica que o frame transmitido possui baixa prioridade de entrega em relação aos outros frames?
Olá,
Você é mesmo bom em subnetting?
Prove aqui o seu conhecimento e concorra a uma bolsa intergral para o nosso famoso "5 dias de treinamento CCNA". São 6 questões sobre subnetting e...
Questions: 6 | Attempts: 365 | Last updated: Feb 14, 2013
-
Sample QuestionQual é o último endereço válido de rede em 192.168.157.0 255.255.255.248 ?
Questions: 50 | Attempts: 364 | Last updated: Jan 29, 2013
-
Sample QuestionWhich router component is used to store the routing table?
Full-ccna
Questions: 51 | Attempts: 364 | Last updated: Jan 21, 2013
-
Sample QuestionRefer to the exhibit. An administrator documented the output of a CAM table from an Ethernet switch as shown. What action will the switch take when it receives the frame shown at the bottom of the exhibit?
NHUNIVERSITY ONLINE TESTING ENGINE
Questions: 20 | Attempts: 361 | Last updated: Apr 18, 2013
-
Sample QuestionWhich two of the following are not main characteristics of Cisco Unified Communications Manager Express? (Choose two.)
THE CISCO CCNA EXAM OBJECTIVESCOVERED IN CHAPTER 1
Questions: 3 | Attempts: 348 | Last updated: Jan 2, 2013
-
Sample QuestionWhich of the following allows a router to respond to an ARP request that is intended for aremote host?
CCNA: Routing Protocols & Concepts. Chapter 8. The Routing Table: A closer look.
Questions: 19 | Attempts: 347 | Last updated: Jul 30, 2011
-
Sample QuestionRefer to the exhibit. What can be determined from this output?
Questions: 50 | Attempts: 346 | Last updated: Jun 12, 2013
-
Sample Question1. Refer to the routing table shown in the exhibit. What is the meaning of the highlighted value 192?
Your studies on the Exploration curriculum under the overarching Cisco Certified Network Associate have led you to this moment – it’s your final exam! Are you fully prepared to walk out with a certification that...
Questions: 52 | Attempts: 327 | Last updated: Jan 4, 2019
-
Sample QuestionRefer to the exhibit. The network administrator needs to setup Switch1 for remote access from HostA. Theshow ip interface brief is issued on Router1 and the show interfaces trunk command is issued on theSwitch1 to verify the current status. The administrator applies the additional configuration shown in theexhibit to Switch1. However, the telnet from HostA fails. What additional commands need to be appliedto the switch?
With the midterms drawing nearer there is an increased need to have proper revision before you have to sit for them. The quiz below is designed to help you pass the CCNA 2 midterms without a hitch. Give it a shot and share it...
Questions: 21 | Attempts: 308 | Last updated: Nov 29, 2018
-
Sample QuestionWhere is permament storage for the Cisco IOS stored
Questions: 19 | Attempts: 294 | Last updated: Dec 14, 2012
-
Sample QuestionA single 802.11g access point has been configured and installed in the center of a square office. A few wireless users are experiencing slow performance and drops while most users are operating at peak efficiency. What are three likely causes of this problem? (Choose two.)
CCNA Routing Protocols & Concepts. Chapter 10: Link-State Routing Protocols.
Questions: 19 | Attempts: 266 | Last updated: Jul 30, 2011
-
Sample QuestionRefer to the exhibit. When Router D is configured to use a link-state routing protocol and is added to the network, what is the first thing that it does to begin learning the network topology?
Have you just started on your journey to the CCCNA certification? The quiz below is designed to test out what you recall from the CCNA 3 chapter one and is in league with the current syllabus. Take it up and get to understand...
Questions: 17 | Attempts: 261 | Last updated: Nov 29, 2018
-
Sample Question1 Link aggregation should be implemented at which layer of the hierarchical network?
CCNA 2 chapter 3 is a very interesting chapter and takes us deeper into what networking is all about. Take up the quiz and get to test your understanding of the chapter 3 and all it covered. All the best and remember that the...
Questions: 17 | Attempts: 246 | Last updated: Nov 29, 2018
-
Sample QuestionWhich command would the network administrator issue to determine if load balancing is in effect router?
All the questions and answers for the CCNA2 Final Exam can be found on ccna5.net.Their quiz only covers the first 58 questions, for the other 44 questions listed under "new questions", this quiz was made. If you combine...
Questions: 44 | Attempts: 228 | Last updated: Jan 12, 2016
-
Sample QuestionA network technician has been asked to secure all switches in the campus network. The security requirements are for each switch to automatically learn and add MAC addresses to both the address table and the running configuration. Which port security configuration will meet these requirements?
Quiz to help your remember the most common CIDR Subnet masks. ie... What is the subnet mask for a CIDR of /25?This quiz is for the most common CIDR's ranging from /17 - /30
Questions: 14 | Attempts: 221 | Last updated: Jul 30, 2011
Love it
Questions: 11 | Attempts: 198 | Last updated: Dec 31, 2012
-
Sample Question1. Users in the network are experiencing slow response time when doing file transfers to a remote server. What command could be issued to determine if the router has experienced any input or output errors?
CCNA EWAN Final Exam
Questions: 55 | Attempts: 196 | Last updated: Jan 15, 2013
-
Sample QuestionA technician has been asked to run Cisco SDM one-step lockdown on the router of a customer. What will be the result of this process?
