CCNA WAN Quizzes & Trivia

Top Trending

Welcome to today’s quiz, which aims to further your studies on a very important part of your ongoing studies for your Cisco Certified Network Associate – the Wide Area Network (WAN), which is a computer network which...

Questions: 22 | Attempts: 1030 | Last updated: Jul 12, 2021

Sample Question
At which two layers of the OSI model does a WAN operate? (Choose two.)

Physical Layer

Data Link Layer

Network Layer

Presentation Layer

Transport Layer

CCNA Wan Chapter 5

CCNA WAN Chapter 5

It’s the fifth chapter of your studies on wide area networks, which span much further distances than LANs and can extend past a radius of over a kilometre in length, all connected to the same network. Think you have this...

Questions: 26 | Attempts: 378 | Last updated: Jan 4, 2019

Sample Question
By default, how is IP traffic filtered in a Cisco router?

Blocked in and out of all interfaces

Blocked on all inbound interfaces, but permitted on all outbound interfaces

Permitted in and out of all interfaces

Blocked on all outbound interfaces, but permitted on all inbound interfaces

CCNA Wan Chapter 2

CCNA WAN Chapter 2

Welcome to the second chapter of your ongoing studies on the wide area network – a computer network which spans a large area, connecting devices within a radius over a kilometre long. What else can you tell us about these...

Questions: 21 | Attempts: 327 | Last updated: Jan 4, 2019

Sample Question
Which two statements are true about time-division multiplexing (TDM)? (Choose two.)

TDM relies on Layer 3 protocols to operate.

Multiple sources can transmit over a single channel.

Original data streams must be reconstructed at the destination.

TDM methods vary depending on the Layer 2 protocol that is used.

It allows information from multiple channels to be allocated bandwidth on multiple wires

Do You Know CCNA Wan Final? Play This Quiz

Do You Know CCNA WAN Final? Play This Quiz

There has been a lot of information involved in your studies on the wide area network as part of your CCNA certification, but it’s time to put it all together and play this quiz to see if you have learned enough to pass...

Questions: 50 | Attempts: 429 | Last updated: Jan 4, 2019

Sample Question
What will be the result of adding the command ip dhcp excluded-address 172.16.4.1 172.16.4.5 to the configuration of a local router that has been configured as a DHCP server?

Traffic that is destined for 172.16.4.1 and 172.16.4.5 will be dropped by the router.

Traffic will not be routed from clients with addresses between 172.16.4.1 and 172.16.4.5.

The DHCP server function of the router will not issue the addresses between 172.16.4.1 and 172.16.4.5.

The router will ignore all traffic that comes from the DHCP servers with addresses 172.16.4.1 and 172.16.4.5.

A Quiz On CCNA Wan Chapter 3

A Quiz On CCNA WAN Chapter 3

Once again, we are back with another chapter of your studies on wide area networks, where today we’ll be looking at the third instalment of information regarding the topic. Think you know all there is to know about WANs...

Questions: 22 | Attempts: 301 | Last updated: Jan 4, 2019

Sample Question
Refer to the exhibit. Router R1 has been configured for Frame Relay connectivity to routers R2 and R3. Which set of configuration options for routers R2 and R3 would provide each router connectivity to R1?

R2(config)# interface serial0/0/1 R2(config-if)# frame-relay map ip 10.1.1.1 102 R3(config)# interface serial0/0/1 R3(config-if)# frame-relay map ip 10.1.2.1 103

R2(config)# interface serial0/0/1 R2(config-if)# frame-relay map ip 10.1.1.1 102 R2(config-if)# frame-relay map ip 10.1.2.3 301 R3(config)# interface serial0/0/1 R3(config-if)# frame-relay map ip 10.1.2.1 103 R3(config-if)# frame-relay map ip 10.1.1.2 201

R2(config)# interface serial0/0/1 R2(config-if)# frame-relay map ip 10.1.1.1 102 R2(config-if)# frame-relay map ip 10.1.2.3 301 R3(config)# interface serial0/0/1 R3(config-if)# frame-relay map ip 10.1.2.1 103 R3(config-if)# frame-relay map ip 10.1.1.2 201

R2(config)# interface serial0/0/1.201 point-to-point R2(config-if)# frame-relay interface-dlci 201 R3(config)# interface serial0/0/1.301 point-to-point R3(config-if)# frame-relay interface-dlci 301

CCNP CCNP Quizzes

CIW CIW Quizzes

CompTIA CompTIA Quizzes

CCNA WAN Chapter 4: Network Security

Questions: 22 | Attempts: 210 | Last updated: Jan 11, 2013

Sample Question
What is the best defense for protecting a network from phishing exploits?

Schedule antivirus scans.

Schedule antispyware scans .

Schedule training for all users.

Schedule operating systems updates.

The Candid Test On CCENT - Wan

The candid test on CCENT - WAN

IT certifications show employers that you have demonstrable skills in that area, making them more likely to want to hire you and leading to higher salary offers. What do you know about wide area networks from you CCENT...

Questions: 17 | Attempts: 138 | Last updated: Nov 29, 2018

Sample Question
Cables used to connect to external CSU/DSU (choose 5)

EIA/TIA-232 (RS232)

EIA/TIA-449

Rolled

Serial

RJ-48

V.35

A Unique Quiz On CCNA Wan 4 Ch 8

A Unique quiz on CCNA WAN 4 CH 8

Welcome to the eighth chapter of our quiz series on wide area networks, as taught by the Cisco Certified Network Associate to give you knowledge on how these networks are able to span radiuses in excess of a kilometre in length....

Questions: 20 | Attempts: 117 | Last updated: Jan 4, 2019

Sample Question
1. Which two pieces of information are typically found on a logical network diagram? (Choose two.)

• cable types

• connector types

• interface identifiers

• DLCI for virtual circuits

• operating system versions