Advertisement

Advertisement

Advertisement

Aviation Quizzes, Questions & Answers

Recent Aviation Quizzes

Hardest Trivia Questions On Flight Operations and Responsibilities! Quiz

Questions: 92 | Attempts: 128 | Last updated: Mar 20, 2025

Sample Question
When must you notify the training section that qualification training is complete?

The first duty day following completion.

Within 30 days of completion.

72 hours after completion.

48 hours after completion.

You Think Are You An Avgeek?

Questions: 206 | Attempts: 4891 | Last updated: Mar 21, 2025

Sample Question
In what year did the first commerical jet plane make its maiden flight?

1947

1963

FAA Instrument Quiz #5

Questions: 15 | Attempts: 490 | Last updated: Mar 19, 2025

Sample Question
1. (Refer to figure 98 on page 2-102 and figure 99 on page 2-103 To which aircraft position does HSI presentation "B" correspond?

A-9

B--13

C-19

Option 4

CDC 2r051 Eoc Practice Test

Questions: 559 | Attempts: 1016 | Last updated: Mar 19, 2025

Sample Question
(001) Air Force policy on air and space equipment maintenance expects maintenance to be performed at the

Lowest level

Highest level

Depot facility

Contractor facility

Ex. 12 - Stalls

Questions: 10 | Attempts: 468 | Last updated: Mar 22, 2025

Sample Question
What is a stall in an airplane?

Flight beyond the critical angle of attack; i.e., the angle of attack beyond which increasing the angle of attack will decrease, not increase, lift

Flight below the critical airspeed; i.e., the airspeed given in the POH below which the wing will no longer produce lift

A condition in which the plane's engine has stopped because the propeller blades exceeded the critical angle of attack

A sudden nose drop and a rapid descent at high airspeed, caused by excessive nose-up attitude of the airplane

Embraer Jet 170/190 Limitations

Questions: 42 | Attempts: 673 | Last updated: Mar 19, 2025

Sample Question
Max allowable runway slope?

-2% to +2%

-2.1% to +2%

-2.1% to -2.1%

2% to -2.1%

Ex. 7 - Climbing

Questions: 10 | Attempts: 233 | Last updated: Mar 22, 2025

Sample Question
When would it be wise to climb at Vx (the speed for the best angle of climb)?

Whenever changing cruise altitudes on a long cross-country flight

When air traffic control asks you to "expedite" your climb

Right after take-off from a short runway with an obstacle near the end.

Whenever overheating the engine is a concern

Airplane: How Much You Know About Precautionary Landing? Quiz

Questions: 10 | Attempts: 105 | Last updated: Mar 20, 2025

Sample Question
As a rule of thumb, how should you set up the plane for a field inspection during a precautionary landing?

Normal cruise speed -- because you're most comfortable with that configuration and can concentrate on inspecting the field as opposed to flying the plane.

Slow cruise (70 knots, 10 degrees of flaps in a Cessna) -- because the plane is stable and safe in that configuration, yet slow enough to allow enough time for a good inspection.

Slow flight (below best endurance, 20 degrees of flaps in a Cessna) -- because it allows you the most time to conduct a detailed inspection.

Ex. 6 - Straight and Level Flight

Questions: 10 | Attempts: 234 | Last updated: Mar 20, 2025

Sample Question
What is the purpose of an elevator trim tab?

It allows you to change the plane's pitch attitude without handling the yoke.

It allows you to "trim off" the control pressure, so you don't have to continuously pull or push on the yoke.

It allows you to "trim off" the rudder pressure, so that you can fly coordinated (i.e., ball in the centre of Turn & Bank Coordinator), so you don't have to continuously push on a rudder pedal.

It's basically another word for autopilot -- it keeps your altitude while you fly "hands-off".

Day 7 - Flight Controls, Navigation

Questions: 21 | Attempts: 111 | Last updated: Aug 22, 2025

Sample Question
What does operation of the aileron trim switches do?

Repositions the neutral position of the aileron feel and centering unit & displaces both control wheels.

Repositions the neutral position of the aileron feel and centering unit & displaces FOs control wheels.

Repositions the neutral position of the aileron feel and centering unit & displaces Cpts control wheels.

Repositions the up position of the aileron feel and centering unit & displaces both control wheels.

« Previous 1 234 5 Next »

Advertisement