ICND P2 V2 M5

1. Which command must you configure for EIGRP to pass the subnet mask with the route? (Source: Troubleshooting EIGRP)

Ip classless

No auto-summary

No summary

Ip subnet vism

2. What does the EIGRP message “neighbor not on common subnet” mean? (Source: Troubleshooting EIGRP)

There are duplicate EIGRP router IDs.

The two adjacent neighbor interfaces do not have addresses in the same IP network.

The MTU sizes on the two adjacent neighbor routers do not match.

The EIGRP network command was not in the classless format.

3. Which command correctly specifies that network 10.0.0.0 is directly connected to a router that is running EIGRP? (Source: Implementing EIGRP)

Router(config)#network 10.0.0.0

Router(config)#router eigrp 10.0.0.0

Router(config-router)#network 10.0.0.0

Router(config-router)router eigrp 10.0.0.0

4. Which command displays the amount of time since the router heard from an EIGRP neighbor? (Source: Implementing EIGRP)

Show ip eigrp traffic

Show ip eigrp topology

Show ip eigrp interfaces

Show ip eigrp neighbors

5. How do you minimize the bandwidth requirement for EIGRP packets? (Source:Implementing EIGRP)

By propagating only data packets

By propagating only hello packets

By propagating only routing table changes and hello packets

By propagating the entire routing table only to those routers that are affected by a topology change

6. Which form of authentication does EIGRP support? (Source: Implementing EIGRP)

Plaintext

3DES

MD5

Both A and C

7. Which command displays whether route filtering has been enabled? (Source: EIGRP)

Show interface

Show access-list

Show ip protocols

Show route-filter