2w051a Vol.3 Ure Questions I.Y.A.A.Y.A.S
Settings
- 1.Who is responsible for appointing qualified individuals to become certified muitions inspectors ?
- A.
Executive Office
- B.
Unit Commander
- C.
Element Chief
- D.
Flight Chief
- 2.What is the minimum skill level requirement to be a certified munitions inspector ?
- A.
3
- B.
5
- C.
7
- D.
There is no minimum requirement
- 3.Who, along with the muntiotions control and muntuions supervision, must inspectors imediately notify upon discovering restricted or suspended munitions items ?
- A.
MASO
- B.
MAJCOM
- C.
MMX-ALC
- D.
MWR/MMX
- 4.Who has the responsibility to determine and assign the approproate condition codes to munitions assets ?
- A.
The munitions accountable systems officer (MASO)
- B.
The Flight Chief
- C.
Munitions Inspectors
- D.
Munitions accountability personnel
- 5.A combination of 5.56 mm ball and tracer packed together fof field use would be given what type of lot number ?
- A.
Functional
- B.
Regrouped
- C.
Assembled
- D.
Psuedo
- 6.The presence of corrosion represents
- A.
Metal returning to its natural state
- B.
Compounds of the environment blending
- C.
Combining specific alloys to create a specific metal
- D.
Deterioration of the physical properties of each component within a specific metal
- 7.What type of corrosion is identified by damage where the surface is marked with lines but no pits are visible to the naked eye ?
- A.
Pitting
- B.
Etching
- C.
Caked rust
- D.
Developed Crust
- 8.A defect that is likely to result in hazardous or unsafe conditions is classified as
- A.
Minor
- B.
Major
- C.
Critical
- D.
Incidental
- 9.A munitions ite or component never intended or designed to contain explosive material is considered
- A.
Nonexplosive
- B.
Obsolete
- C.
Empty
- D.
Inert
- 10.When you encounter a ballooned barrier bag, what document is followed for specific item instructions ?
- A.
Local OI
- B.
AFI 21-201
- C.
AFMAN 91-201
- D.
Technical Order (T.O.)
- 11.What termis used to conspiciously mark previously opened hermetically sealed containers ?
- A.
UNSEALED
- B.
COMPROMISED SEAL
- C.
NOT HERMETICALLY SEALED
- D.
PRESSURE SENSITIVE SEALED
- 12.Which sentence is not part of the general inspection procedures ?
- A.
Verify suspension or restrictions
- B.
Verify item(s) are suitably packed
- C.
Verify containers are properly marked
- D.
Verify items have at least two months of shelf life remaining
- 13.If defects are found during a recieving inspections that place serviciablity in question, which other type of inspection must be accomplihed on the items ?
- A.
Periodic
- B.
Shipping
- C.
Returned munitions
- D.
Storage monitoring
- 14.A shipping inspection is accomplished to ensure munitions are properly marked/labeled to meet
- A.
Other munitions
- B.
Municipal
- C.
Transportation requirements
- D.
Security forces operations instructions
- 15.Which inspection provides a high degree of confidence that the munitions have not been adersely affected by the environment, storage conditions, age, or use ?
- A.
Returned munitions inspection
- B.
Pre-issue inspection
- C.
Periodic inspection
- D.
Special inspection
- 16.What type of inspection is performed to ensure an item is suitable for its intended use before it is signed over to a user ?
- A.
Periodic (PI)
- B.
Shipping (SI)
- C.
Recieving (RI)
- D.
Pre-issue (PII)
- 17.Who is responsible for managing the installation's storage monitoring inspection program ?
- A.
Storage section chief
- B.
Munitions flight chief
- C.
Senior munitions inspector
- D.
Munitions accountable systems officer
- 18.Which response best describes condition code B ?
- A.
Serviceable without qualification
- B.
Serviceable with qualification
- C.
Serviceable but priority issue
- D.
Unserviceable repairable
- 19.Condition code C is best described as
- A.
Serviceable without qualification
- B.
Serviceable with qualification
- C.
Serviceable, priority issue
- D.
Unserviceable repairable
- 20.Which selection best describes condition code N ?
- A.
Suspended for emergency combat use only
- B.
Serviceable without qualification
- C.
Serviceable with qualification
- D.
Unserviceable repairable
- 21.Munitions in what condition are tagged with DD Form 1574/1574-1 (yellow tag) ?
- A.
Repairable
- B.
Serviceable
- C.
Condemned
- D.
Unserviceable
- 22.Which unserviceable item tag is used on munitions that are uneconomical repair ?
- A.
DD Form 1574
- B.
DD Form 1575
- C.
DD Form 1577-2
- D.
DD Form 1577
- 23.Which AFTO IMT Form is used ti update lot history for units that do not elect direct input of inspection results into combat ammunition system (CAS) ?
- A.
350
- B.
231
- C.
102
- D.
22
- 24.Which database must you update historical records in to allow the disposal of the AFTO IMT Form 102 ?
- A.
MilPDS
- B.
TMRS
- C.
ARMS
- D.
CAS
- 25.What combat ammunition system (CAS) program displays condition and status of stockpile and custody assets ?
- A.
Asset balance inquiry
- B.
Regroup maintenance
- C.
Custody account listing
- D.
Transaction history report
Back to top