Ten100: Chapter 04 Assignment

12 Questions | Total Attempts: 71

SettingsSettingsSettings
Ten100: Chapter 04 Assignment


Questions and Answers
  • 1. 
    According to Lam, what's the purpose of engineering drawing?
  • 2. 
    What do oblique and isometric drawings have in common?
  • 3. 
    Why was Brunellshi's contribution to drawing important? In your answer, describe his contribution.
  • 4. 
    Lam Loc creates drawings to help engineers communicate their ideas more effectively through the use of __________________ , otherwise known as CAD.
  • 5. 
    In an _____________ drawing, the front side of the object appears flat in the picture plane and the sides and top of the object are at a 45-degree angle to the horizontal lines of the front side.
  • 6. 
    The imaginary point on the horizon in which an object's parallel lines appear to converge is called the __________________.
  • 7. 
    In a ______________ drawing, the lines of the object that move away from the viewer converge on an imaginary point called the vanishing point.
  • 8. 
    In an ______________ drawing all vertical lines are drawn at 30 degrees to the horizontal, allowing engineers to communicate measurements of an object.
  • 9. 
    _______________ refers to the ratio of an object in a drawing to the size of the object in real life.
  • 10. 
    The ratio of the size of the drawing and the size of the object is called the _______________.
  • 11. 
    The _________________ is a system of measurements in which the standard unit for length is one meter.
  • 12. 
    A(n) _______________ drawing is a 2D, or flat, drawing of each side of an object used to communicate the dimensions of a design.
Back to Top Back to top