Frontier Quiz 7 Compound Miter Saw
8 Questions
| Total Attempts: 194
Settings
Compound Miter saw safety
Questions and Answers
- 1.Be sure the saw blade is_____________, has proper clearance, and is free from vibration the same brand as the saw
- A.
For ripping
- B.
Sharp
- C.
Maximum
- D.
Diameter
- 2.Always be sure your work is held firmly against the____________________ .
- A.
Table
- B.
Brake
- C.
Saw blade
- D.
Fence
- 3.If the material is bowed, twisted, or warped____________________________, .
- A.
Use extra care in cutting
- B.
It is ok to cut
- C.
Do not cut it
- D.
Give it to another student
- 4._______________the arm lock knob before a cut is made. .
- A.
Remove
- B.
Loosen
- C.
Tighten
- D.
Turn
- 5.If the saw is equipped with a brake, be sure to______________ the trigger switch before you apply the saw brake.
- A.
Hold
- B.
Remove
- C.
Watch
- D.
Release
- 6.Be sure the machine is____________________ before reaching to pick up a piece of work or anything that is in or near the cutting path of the blade.
- A.
Slowing down
- B.
At a full stop
- C.
Turned off
- D.
Operating
- 7.Any cutting operation which requires a special set-up must be approved by the instructor___________________
- A.
Prior to the start of the operation
- B.
During the cutting operation
- C.
After the cut is made
- D.
Halfway through the cutting operation
- 8.Do not place your fingers closer than_____________ inch(es) from the path of the saw blade.
- A.
2
- B.
1
- C.
4
- D.
1/2
Back to top