Aet1 2nd Nine Weeks Practice AutoCAD Questions
Settings
-
+
- 1.You can alternate between the Trim command and the Extend command by:
- A.
Using the right-click shortcut menu
- B.
Picking with the left-mouse button when done
- C.
Performing a right-click with your mouse or pressing Enter on the keyboard
- D.
Holding the "Shift" key down
- 2.What is the most important thing to read when using AutoCAD?
- A.
Ribbon panel
- B.
Command prompt
- C.
Drawing area
- D.
Status bar
- 3.
- A.
Returns to your previous zoomed view
- B.
Cancels out of the current command
- C.
Starts a new command
- D.
Restarts the previous command
- E.
Opens a new file
- 4.When drawing in AutoCAD, what layer does your new geometry land on?
- A.
0
- B.
A-Wall
- C.
Object Layer
- D.
The newest layer created
- E.
The current layer
- 5.In AutoCAD, where do you create and manage layers?
- A.
Layer Settings Manager
- B.
Layer Options Manager
- C.
Layer Status Manager
- D.
Layer Properties Manager
- E.
Command Prompt
- 6.In AutoCAD, which of the following is not a valid Object Snap?
- A.
Quarter
- B.
Perpendicular
- C.
Nearest
- D.
Endpoint
- E.
Node
- 7.In AutoCAD, what does Ortho mode do?
- A.
Keeps the cursor at 5 degree increments
- B.
It is a type of line
- C.
Keeps the cursor moving either vertical or horizontal
- D.
It is a workspace
- E.
It turns on all available snaps
- 8.Where would you find the settings for your dimensions in an AutoCAD drawing?
- A.
Dimension Styles
- B.
Dimension Options
- C.
Dimension Types
- D.
Dimension Units
- E.
Dimension Characteristics
- 9.Which is not a valid zoom command in AutoCAD?
- A.
Window
- B.
Realtime
- C.
Down
- D.
Extents
- E.
Previous
- F.
Dynamic
- G.
Scale
- 10.There are two methods for placing a Hatch in an AutoCAD drawing. One is selecting boundary objects and the other is:
- A.
Remove boundary objects
- B.
Pick points
- C.
Island detection
- D.
Draw hatch lines
- E.
Identify boundary hatch
- 11.Which of the following does the CAD in AutoCAD stand for?
- A.
Coronary artery disease
- B.
Computer-assisted drawing
- C.
Computer-aided drawing
- D.
Computer-aided design
- E.
Computers and design
- 12.The Offset command allow you to make copies that are either:
- A.
Parallel or perpendicular
- B.
Parallel or concentric
- C.
Parallel or tangent
- D.
Concentric or tangent
- 13.The Fillet command can be used to:
- A.
Trim a line
- B.
Create a radius or round between two non-parallel line segments
- C.
Cut a corner off a rectangle
- D.
Change the current layer
Back to top