My Lcsc Safety Quiz
- 1.When does a Work Clearance Form (WCF) need to be filled out?
- A.
Only for electrical work
- B.
Only if the work is going to take more than 2 hours
- C.
For all work tasks
- D.
Only for high risk work
- 2.There are three (3) key areas in the JHA form. These are Job Step, Job Step Hazard and Job Step ..........
- A.
Control
- B.
Risk
- C.
Measure
- 3.What do you believe is the minimum Personal Protective Equipment that must be worn on site?
- A.
Gloves, goggles, high visibility vest
- B.
Safety helmet, high visibility vest, safety footwear
- C.
Long pants, gloves, safety footwear
- D.
Safety helmet, shirt, goggle
- 4.Which of the forms must be used when performing 'hot work' or work that could cause a spark in a hazardous area?
- A.
WCF
- B.
JHA
- C.
Permit To Work
- D.
All the above
- 5.When does a 'Safe Working Area' need to be created?
- A.
15 minutes after we have started the work
- B.
Before any work begins - every time
- C.
Only if there are a lot of people visiting the site at that time
- 6.Aside from placing barriers and signage, what additional steps should we use to ensure unauthorized people do not enter into your 'Safe Working Area'?
- A.
By telling people who walk past
- B.
By telling the site representative
- C.
By wearing high visibility clothing
- D.
All the above
- 7.Which of the following is a Life Saving Rule?
- A.
Wear a seat belt when in a moving vehicle
- B.
Do not use a mobile phone while driving
- C.
Do not smoke outside of the designated smoking areas
- D.
All of the above
- 8.What is the Shell definition of 'Work at Height'?
- A.
Any work where you are above ground level
- B.
Work which is higher than 1.8 meters
- C.
Work performed where a potential fall distance of 1.8 meters (6 feet) or more exists
- D.
All of the above
- 9.What action must be taken if the work creates a potential fall distance greater than 1.8 meters (6 feet)?
- A.
Take turns to complete the work
- B.
Complete a JHA form, and use the appropriate 'Work at Height' equipment
- C.
No new action, complete the work with my standard PPE
- D.
None of the above
- 10.A Last Minute Risk Assessment is
- A.
Use to identify any new risks while carrying out the work task
- B.
Only needed if we start the work late
- C.
Only necessary if working alone
- 11.Why should we report incidents?
- A.
To keep the supervisor happy
- B.
To show work is being done
- C.
To provide information that can be used to prevent a future incident
- 12.What should you do if an emergency occurs on site?
- A.
Call passers-by to come and help
- B.
Ignore it and let someone else deal with it
- C.
Follow your company's emergency rescue plan, and inform your supervisor
- 13.There is more risk of having an incident if
- A.
We slow down and take our time
- B.
We do the same task everyday
- C.
We are concentrating
- 14.As a worker on site, I have the responsibility to
- A.
Hide incidents in case I get in trouble
- B.
Just complete my task
- C.
Always follow procedure, and report unsafe conditions or acts
- 15.With good personal awareness, we can
- A.
Always carry out a personal check of our equipment
- B.
Slow down, take our time and think about the task we are doing
- C.
All of the above
Questions: 10 | Attempts: 156 | Last updated: Nov 17, 2014
-
Sample QuestionWhat are the weekly requirements of a Her Campus chapter?
Questions: 8 | Attempts: 255 | Last updated: Jul 21, 2015
-
Sample QuestionIf you had an extra hour in the day, which of these subjects would you like to spend more time studying?
Questions: 10 | Attempts: 409 | Last updated: Apr 19, 2019
-
Sample QuestionWhat type of comic is my hero academia?
Back to top