# Trivia Questions Quiz On Formula Student Rules: Germany!

Approved & Edited by ProProfs Editorial Team
The editorial team at ProProfs Quizzes consists of a select group of subject experts, trivia writers, and quiz masters who have authored over 10,000 quizzes taken by more than 100 million users. This team includes our in-house seasoned quiz moderators and subject matter experts. Our editorial experts, spread across the world, are rigorously trained using our comprehensive guidelines to ensure that you receive the highest quality quizzes.
| By Umer_20th1
U
Umer_20th1
Community Contributor
Quizzes Created: 1 | Total Attempts: 2,668
Questions: 10 | Attempts: 2,668

Settings

Below is a Trivia-Questions Quiz On Formula Student Rules in Germany! If you are looking to audition for competitions in formula one driving as a student you must know some of the rules that each racer has to follow and the quiz below is perfect for seeing how well you understand them. How about you give it a shot and see if you would qualify.

• 1.

### The minimum distance between 95th percentile lower 200 mm circle and face of the pedal?

• A.

925 mm

• B.

920 mm

• C.

37 in

• D.

36 in

D. 36 in
Explanation
The correct answer is 36 in. The question is asking for the minimum distance between the 95th percentile lower 200 mm circle and the face of the pedal. This implies that there is a circle with a radius of 200 mm, and the 95th percentile of this circle is being considered. The distance between this circle and the face of the pedal is 36 inches.

Rate this question:

• 2.

### What is the maximum angle which the lower portion of the Main hoop (i-e below upper side impact member) can make with the horizontal when inclined rearward?

• A.

No limit

• B.

10

• C.

80

• D.

45

C. 80
Explanation
The maximum angle which the lower portion of the Main hoop can make with the horizontal when inclined rearward is 80 degrees.

Rate this question:

• 3.

### The engine lubrication system of your vehicle has a capacity of 12.5l. In the driving condition, it is 80% filled with the fluid. What is the minimum volume of catch can?

• A.

1l

• B.

0.9l

• C.

1.1l

• D.

1.2l

A. 1l
Explanation
The minimum volume of the catch can should be 1 liter. This is because the engine lubrication system has a capacity of 12.5 liters and is currently 80% filled with fluid. In order to prevent overflow or leakage, the catch can should be able to hold at least the remaining 20% of the fluid, which is 2.5 liters. Therefore, the minimum volume of the catch can should be 1 liter to accommodate this amount.

Rate this question:

• 4.

### Which one meets the positive locking requirement?

• A.

Washers

• B.

Cotter pins

• C.

Bolts with nylon patches

• D.

Loctite

B. Cotter pins
Explanation
Cotter pins meet the positive locking requirement because they are designed to securely hold two components together by passing through a hole and then bending the ends to prevent them from coming out. This ensures that the connection remains locked and prevents any unintentional disassembly or movement.

Rate this question:

• 5.

### Runner system between restrictor and throttle body is made up of rectangular cross-section with height 55mm. What is the possible width of the runner system?

• A.

60mm

• B.

50mm

• C.

55mm

• D.

65mm

B. 50mm
Explanation
The possible width of the runner system is 50mm. This can be deduced from the information given in the question, which states that the runner system has a rectangular cross-section with a height of 55mm. Since no other dimensions or ratios are provided, it can be assumed that the width is equal to the height, resulting in a width of 50mm.

Rate this question:

• 6.

### What is the penalty, if a team is not able to submit a notice of intent or FMEA of ETC by the due date?

• A.

-10 point daily till max -50 points

• B.

Disqualification from competition

• C.

Back to mechanical throttle

• D.

No penalty

C. Back to mechanical throttle
Explanation
If a team is not able to submit a notice of intent or FMEA of ETC by the due date, the penalty is that they will have to revert back to using a mechanical throttle. This means that they will lose the ability to use electronic throttle control and will have to rely on a traditional mechanical system. There is no mention of any other penalties such as point deductions or disqualification from the competition.

Rate this question:

• 7.

### Which of the following is not a requirement of the Cost report?

• A.

Font size 10 point or higher

• B.

Page size A4

• C.

Page size 8.5in x 11in

• D.

Must not exceed 8 pages

D. Must not exceed 8 pages
Explanation
The requirement of the Cost report that is not mentioned in the given options is that it must not exceed 8 pages. The other options mention requirements such as font size, page size, and the specific dimensions of the page, but they do not mention anything about the length of the report. Therefore, the correct answer is "must not exceed 8 pages".

Rate this question:

• 8.

### In Autocross Event, which flag is used to indicate the approval to begin?

• A.

Blue flag

• B.

Red flag

• C.

Green flag

• D.

Red-yellow striped

C. Green flag
Explanation
The green flag is used to indicate the approval to begin in an Autocross Event. This flag is commonly used in motorsports to signal the start of a race or event. Once the green flag is waved, it signifies that the track is clear and participants can start their vehicles and begin the competition.

Rate this question:

• 9.

### In an endurance event, if a team exceeds Tmax time then how much points the team score?

• A.

50

• B.

25

• C.

10

• D.

0

B. 25
Explanation
If a team exceeds Tmax time in an endurance event, the team will score 25 points. This suggests that there is a penalty for going over the allotted time, and the penalty is a deduction of 25 points from the team's score.

Rate this question:

• 10.

### Which of the following act results in penalty?

• A.

Alcohol and illegal material

• B.

Arguments with official

• C.

Unsportsmanlike conduct

• D.

Failed to follow an official instruction

D. Failed to follow an official instruction
Explanation
Failing to follow an official instruction can result in a penalty because it goes against the rules and regulations set by an authority figure. This act shows a lack of respect for authority and can disrupt the proper functioning of a system or organization. Therefore, penalties are imposed to discourage such behavior and maintain order and discipline.

Rate this question:

Quiz Review Timeline +

Our quizzes are rigorously reviewed, monitored and continuously updated by our expert board to maintain accuracy, relevance, and timeliness.

• Current Version
• Mar 21, 2023
Quiz Edited by
ProProfs Editorial Team
• Jan 25, 2015
Quiz Created by
Umer_20th1

Related Topics