CISCO Commands

12 Questions | By Msmith721 | Updated: Feb 21, 2012 | Attempts: 776

Questions

Settings

Cisco Commands

Questions and Answers

1.

Activates the configuration mode from the terminal
2.

Copies the switch running configuration file to the startup configuration.
3.

Activates the EXEC mode. In privileged EXEC mode, more commands are available. This command requires you to enter the enable password if an enable password is configured
4.

Protects access to the enable mode. However, this password is stored in cleartext in the configuration. HINT: Use Cisco as the password in your answer
5.

Protects access to the enable mode, with an encrypted enable password. An enable secret password overrides the cleartext enable password if both are configured. HINT: Use sanfran as the password
6.

Terminates the configuration mode.
7.

Erases the startup configuration that is stored in the nonvolatile memory (NVRAM).
8.

Sets the system name, which forms part of the prompt. HINT: Use Router1 as the hostname
9.

Enters the interface configuration mode for VLAN 1
10.

Sets the IP address and mask of the interface. Use Ip address 172.122.122.10 and mask of 255.255.255.0
11.

Sets the default gateway of the switch. The default gateway is the router, which will forward IP packets that are not destined for the local network. Use 10.10.0.5 as the DG
12.

Enters the vty configuration mode. Vty lines allow access to the switch for remote network managment. The number of vty lines that are available is dependent on the Cisco IOS Software version. Typical values are 0-4 and 0-15. Use the command for 0 thru 15.

Quiz Review Timeline +

Our quizzes are rigorously reviewed, monitored and continuously updated by our expert board to maintain accuracy, relevance, and timeliness.

Related Topics

Recent Quizzes

Featured Quizzes

Back to top