300-101 Other User

17 Questions | Attempts: 323
Share

SettingsSettingsSettings
Network Quizzes & Trivia

.


Questions and Answers
  • 1. 

    A network engineer executes the show ip cache flow command. Which two types of information are displayed in the report that is generated? (Choose two)

    • A.

      Top talkers

    • B.

      Flow export statistics

    • C.

      Flow sample for specific protocols

    • D.

      MLS flow traffic

    • E.

      IP packet distribution

    Correct Answer(s)
    C. Flow sample for specific protocols
    E. IP packet distribution
  • 2. 

    Which DHCP option provides a TFTP server that Cisco phones can use to download a configuration

    • A.

      DHCP Option 66

    • B.

      DHCP Option 68

    • C.

      DHCP Option 82

    • D.

      DHCP Option 57

    Correct Answer
    A. DHCP Option 66
  • 3. 

    Which access list entry checks for an ACK within a packet header?

    • A.

      Access-list 49 permit ip any any eq 21 tcp-ack

    • B.

      Access-list 49 permit tcp any any eq 21 tcp-ack

    • C.

      Access-list 149 permit tcp any any eq 21 established

    • D.

      Access-list 49 permit tcp any any eq 21 established

    Correct Answer
    C. Access-list 149 permit tcp any any eq 21 established
  • 4. 

    Which option is one way to mitigate symmetric routing on an active/active firewall setup for TCP-based connections?

    • A.

      Performing packet captures

    • B.

      Disabling asr-group commands on interfaces that are likely to receive asymetric traffic

    • C.

      Replacing them with redundant routers and allowing load balancing

    • D.

      disabling stateful TCP checks

    Correct Answer
    D. disabling stateful TCP checks
  • 5. 

    Which feature enables security in vty lines?

    • A.

      Exec-time out

    • B.

      Logging

    • C.

      Username and password

    • D.

      Transport out

    Correct Answer
    C. Username and password
  • 6. 

    Command in uRPF loose mode

    • A.

      Ip verify unicast source reachable-via any

    • B.

      Option 2

    • C.

      Option 3

    • D.

      Option 4

    Correct Answer
    A. Ip verify unicast source reachable-via any
  • 7. 

    What are the two scenarios for preventing fragmentation on GRE tunnel? (Choose two)

    • A.

      TCP MSS

    • B.

      DF Bit Clear

    • C.

      IP MTU

    • D.

      PMTUD

    Correct Answer(s)
    A. TCP MSS
    D. PMTUD
  • 8. 

    Given ((diagram with R1 SLA config)) with configuration written on Picture as“R(Config)#ip sla 1R1(Config-ip-sla)#icmp-echo 172.20.20.2 source-interface f1/0R1(Config-ip-sla)#frequency 10R1(Config-ip-sla)#threshold 100R1(Config)#ip sla schedule 1 start-time now life foreverR1(Config)#track 10 ip sla ???-R1(Config)#ip route 0.0.0.0.0 0.0.0.0 172.20.20.2What make default route not removed when SLA state down or failed?

    • A.

      The destination must be 172.30.30.2 for icmp-echo

    • B.

      The threshold value is wrong

    • C.

      Option 3

    • D.

      Missing of track feature on default static route command

    Correct Answer
    D. Missing of track feature on default static route command
  • 9. 

    Which access list used to filter upper layer protocol?

    • A.

      Extended acl

    • B.

      Option 2

    • C.

      Option 3

    • D.

      Option 4

    Correct Answer
    A. Extended acl
  • 10. 

    A network engineer enables OSPF on a Frame Relay WAN connection to various remote sites, but no OSPF adjacencies come up Which two actions are possible solutions for this issue? (Choose Two)

    • A.

      Change the network type to point-to-multipont under WAN interface

    • B.

      Enable virtual Iinks

    • C.

      Change the network type to nonbroadcast mutpoint access

    • D.

      Configure the neighbor command under OSPF process for each remote site

    • E.

      Ensure that the OSPF process number matches among all remote sites

    Correct Answer(s)
    A. Change the network type to point-to-multipont under WAN interface
    D. Configure the neighbor command under OSPF process for each remote site
  • 11. 

    What’s uRPF checking first when the packet enters the interface? or when unicast reverse patch forwarding is configured on interinterface.

    • A.

      It check the ingress access list

    • B.

      It check the egress access list

    • C.

      Route available in FIB ot it verifies a reverse patch via the fib to the source

    • D.

      It verify that the source has a

    Correct Answer
    C. Route available in FIB ot it verifies a reverse patch via the fib to the source
  • 12. 

    ALWAYS block the outbound web traffic on Saturdays and Sunday between 1:00 to 23:59

    • A.

      Periodic Saturday Sunday 01:00 to 23:59 and IN

    • B.

      Periodic Saturday Sunday 01:00 to 23:59 and OUT

    • C.

      Periodic Saturday Sunday 01:00 to 11:59 and IN

    • D.

      Absolute Saturday Sunday 01:00 to 11:59 and IN

    Correct Answer
    B. Periodic Saturday Sunday 01:00 to 23:59 and OUT
  • 13. 

    What command is needed to get the ip address assigned from the PPPOE server?

    • A.

      Interface dialer

    • B.

      Pppoe enable

    • C.

      Ip address negotiated

    • D.

      Ip address auto negotiated

    Correct Answer
    C. Ip address negotiated

Quiz Review Timeline +

Our quizzes are rigorously reviewed, monitored and continuously updated by our expert board to maintain accuracy, relevance, and timeliness.

  • Current Version
  • Apr 21, 2017
    Quiz Edited by
    ProProfs Editorial Team
  • Mar 30, 2017
    Quiz Created by
    Bradlee
Back to Top Back to top
Advertisement
×

Wait!
Here's an interesting quiz for you.

We have other quizzes matching your interest.