FSG Quiz #13 21.12.2016
.
- 1.
What is the time penalty for not being ready-to-run at the endurance?
- A.
2 minutes
- B.
1 minute
- C.
3 minutes
- D.
4 minutes
Correct Answer
A. 2 minutes -
- 2.
How many team members are allowed to present the cost report real case?
- A.
There is no real case.
- B.
There is no specified limit.
- C.
Only the team captain.
- D.
Maximum two team members.
Correct Answer
A. There is no real case. -
- 3.
What happens when your business plan lasts more than ten minutes?
- A.
The judges will stop it.
- B.
You get additional time, in case a judge asked questions during your presentation.
- C.
You have a 10 seconds buffer.
- D.
Exceeding the ten minutes will relate to penalties. The penalty will depends on your exceeding time but will be not more than 25 points.
Correct Answer
A. The judges will stop it. -
- 4.
What is the total length of the 95th percentile male template when you hold it vertically? (CV & EV)
- A.
0.77 m
- B.
1.02 m
- C.
1.12 m
- D.
1.27 m
- E.
1.835 m
- F.
1.985 m
Correct Answer
E. 1.835 m -
- 5.
Above which temperature are nylon lock nuts not anymore considered as positive locking mechanism?
- A.
50°C
- B.
60°C
- C.
70°C
- D.
80°C
Correct Answer
D. 80°C -
- 6.
What is your Skid Pad Scoring? The average of the left and right timed laps including penalties of your 3 runs are: 5.43s, 6.82s, 5.31s. The lowest corrected elapsed time recorded for any competitor in either heat is 4.90s.
- A.
42 points
- B.
46 points
- C.
48 points
- D.
50 points
- E.
73 points
Correct Answer
A. 42 points -
- 7.
What is the theoretical maximum bending of a round tube with the dimensions of 25x1.25 mm and a total length of 500 mm, when both ends lie freely on a support and a 525 N point load i acting exactly in the middle of the tube´s longitudinal axis (E = 210000MPa)?
- A.
8.84 mm
- B.
0.438 mm
- C.
1.23 mm
- D.
0.848 mm
- E.
0.958 mm
Correct Answer
D. 0.848 mm -
- 8.
During the technical inspection, the car must be capable of being tilted to a certain angle without leaking fluid of any type. What lateral acceleration does this angle correspond to?
- A.
0.58g
- B.
1.00g
- C.
1.56g
- D.
1.24g
- E.
0.71g
- F.
1.70g
- G.
0.87g
Correct Answer
F. 1.70g -
- 9.
What is the maximum height of any part of the rear wing or aerodynamic device in side elevation?
- A.
1.2 m above the ground.
- B.
0.2m above the driver´s head.
- C.
1.2 m above the upper surface of the front tires.
- D.
70mm above the top of the main roll hoop.
- E.
1.0m above the ground.
- F.
1.2m above the minimum ground clearance.
Correct Answer
A. 1.2 m above the ground. -
Quiz Review Timeline +
Our quizzes are rigorously reviewed, monitored and continuously updated by our expert board to maintain accuracy, relevance, and timeliness.
-
Current Version
-
Dec 20, 2016Quiz Edited by
ProProfs Editorial Team -
Dec 20, 2016Quiz Created by
Karaceing
Back to top