V4 Unit 5 CDC's Overall Review

1. (651) The easiest method for measuring distance in a straight line is to use

A ruler.

A compass.

A protractor.

The tick marks.

2. (655) What does the term METT-TC mean?

Movement, enemy, terrain and weather, troops, and time available.

Mission, enemy, territory and weather, troops, and time available.

Movement, enemy, terrain and weather travel, and time available.

Mission, enemy, terrain and weather, troops, and time available.

3. (648) What do contour lines show you when you look at a map?

Relief and elevation on a standard topographic map.

Location in relation to the water.

Location anyplace on a map.

Location on a ridge.

4. (647) What terrain feature is a stretched out groove in the land, usually formed by streams and rivers?

Hill.

Saddle.

Valley.

Depression.

5. (657) Which DAGR mode uses the most power and tracks satellites to produce a continuous PVT solution?

Continuous.

Standby.

Average.

Fix.

6. (649) When reading a topographical map to plot a grid coordinate, you read from

Right to left; bottom to top.

Right to left; top to bottom.

Left to right; bottom to top.

Left to right; top to bottom.

7. (652) Which method is used almost exclusively for sighting and is the best technique for this purpose?

One hand

Two hand.

Center-hold.

Compass to cheek.

8. (652) To ensure proper functioning of a compass, the safe separation distance from telephone wire is

10 meters.

20 meters.

30 meters.

40 meters

9. (652) If you use the watch method to find directions on daylight savings time, the north-south line is between the hour hand and

1100 hours.

1200 hours.

1300 hours.

1400 hours.

10. (648) What types of slope are evenly spaced, but close together?

Steep.

Gentle.

Convex

Concave.

11. (648) What are the three types of contour lines used on a topographic map?

Formed, layered, and supplementary.

Layered, index, and supplementary.

Index, supplementary, and shaded relief.

Index, intermediate, and supplementary.

12. (646) Where can you find the sheet name of a map?

In the corner of the upper left margin and on the right lower margin.

In the center of the center margin and on the right side lower margin.

In the corner of the top margin and on the lower left area margin.

In the center of the top margin and on the lower left area margin.

13. (650) What is the center of the protractor circle from which all directions are measured?

Mils.

Square.

Degrees.

Index mark

14. (654) Which field expedient method is more forgiving of mistakes and less time consuming?

Examining the same piece of terrain during the different seasons of the year.

Matching the terrain to the map by examining terrain features.

Comparing the vegetation depicted on the map.

Navigating by terrain association.

15. (659) How many way points can be entered and stored in the AN/PSN–11?

99.

500.

999.

1000.

16. (653) Which method lets you locate a position using two well-defined locations pinpointed on a map?

Resection.

Intersection.

Modified resection.

Straightedge method.

17. (656) Why is navigating by terrain association preferred over dead reckoning?

Dead reckoning does not allow for errors.

Terrain association uses the compass only.

Errors in navigation are easily correctable.

Navigating by terrain features is more accurate.

18. (658) What consists of a collection of position and movement data for a geographic location?

Security tools.

Situational awareness.

Command and control.

Navigation and route planning.

19. (657) The DAGR provides to the user position

Communication, time reporting, and navigation capabilities.

Range finder, time reporting, and navigation capabilities.

Velocity, time reporting, and navigation capabilities.

Air speed, time reporting, and navigation capabilities.