Scroll Saw Safety

13 Questions | Total Attempts: 3242

SettingsSettingsSettings
Please wait...
Saw Safety Quizzes & Trivia

Scroll Saw safety Quiz


Questions and Answers
  • 1. 
    T or False  You do not need permission to use the scroll saw.
    • A. 

      True

    • B. 

      False

  • 2. 
    You must wear _______________ to use this machine.
    • A. 

      An apron

    • B. 

      Safety glasses

    • C. 

      Hearing protection

  • 3. 
    When installing a blade ensure the teeth are pointing
    • A. 

      Top

    • B. 

      Down

    • C. 

      Teeth

    • D. 

      Back

    • E. 

      Skip

  • 4. 
    Never place hands in the _______ path.
    • A. 

      Blade

    • B. 

      Table

    • C. 

      Teeth

    • D. 

      Motor

  • 5. 
    Always _____________ at the point where the blade is about to cut completely through the wood. If you have too much pressure on the board your hand may slip and go into the blade.
    • A. 

      Slow down and release pressure

    • B. 

      Back up

    • C. 

      Stay on the line

    • D. 

      Stop completely

  • 6. 
    To keep the blade from breaking always _______ wood into the blade as you are turning.
    • A. 

      Keep

    • B. 

      Turn

    • C. 

      Feed

    • D. 

      Hold

    • E. 

      Remove

  • 7. 
    True or false  The scroll saw can be used to cut very sharp curves. (as long as you are cutting as you turn- never stop and turn-you will break the blade.
    • A. 

      True

    • B. 

      False

  • 8. 
    Always have your ____________ with you when you are cutting on this machine!
    • A. 

      Teacher

    • B. 

      Project

    • C. 

      Apron

    • D. 

      Cutter buddy

  • 9. 
    T or F  Never change the blade on the machine.  Always get the instructor to do this.
    • A. 

      True

    • B. 

      False

  • 10. 
    If a blade breaks you should always
    • A. 

      Run away

    • B. 

      Move to a different machine

    • C. 

      Try the exacto knife to make the cut

    • D. 

      Stop the machine and then change the blade

  • 11. 
    Little pieces that are cut off shoild always be
    • A. 

      Thrown into the trash can immediately

    • B. 

      Tossed to the floor and picked up later

    • C. 

      Ignored

    • D. 

      Left on the table

  • 12. 
    Students should always follow the ____________ part of the cut line on the piece they are cutting.  The cut line is the line you draw on the boaed to follow while you are cutting
    • A. 

      Inside

    • B. 

      Middle

    • C. 

      Outside

    • D. 

      Does not matter, you can always sand it down later.

  • 13. 
    T or F Tension Lever (or tension knob)  should be set to highest tension before changing blade.
    • A. 

      True

    • B. 

      False