L1 Certificate In The Principles Of Window And Door Installation (Qcf) Unit 3
J/505/3141 Mandatory Unit: Knowledge of tools and equipment used in the installation of Windows and Doors
- 1.Tools should be left out at all times, so that they can be found easily
- A.
True
- B.
False
- 2.Tools should be checked every time you use them?
- A.
True
- B.
False
- 3.Why is it important to check and maintain tools
- A.
Because it's a nice job to carry out
- B.
Because they will be safer and more efficient to use
- C.
Because they look better when they are clean
- D.
Because your supervisor tells you to do it
- 4.Tools can be stored anywhere as they are very robust?
- A.
True
- B.
False
- 5.Tools with missing safety guards are OK to use as long as you take extra care?
- A.
True
- B.
False
- 6.The best time to recharge a battery powered tool is?
- A.
When you arrive at a new installation
- B.
When you remember to do so
- C.
Immediately after each use
- D.
When it begins to slow down
- 7.Damaged PPE should be changed immediately?
- A.
True
- B.
False
- 8.If you find a tool in need of sharpening, you should?
- A.
Keep using it
- B.
Use it until you have chance to sharpen it
- C.
Sharpen it before you use it
- D.
Press harder to overcome the lack of sharpness
- 9.If any of your powered tools have damaged power leads / cables, you should?
- A.
Replace the power lead cable before further use.
- B.
Apply plenty of electrical tape over the damaged area
- C.
Wear gloves
- D.
Use it as little as possible
- 10.Using damaged equipment is acceptable as long as you take extra care?
- A.
True
- B.
False
- 11.Why are cordless tools generally considered safer than mains powered
- A.
Portable
- B.
Smaller
- C.
Cheaper
- D.
Look better
- 12.Where would you best store tools when not in use?
- A.
In the back of the van
- B.
In a suitable, lockable tool chest
- C.
Wrap them in cloths
- D.
On the floor
- 13.Identify the THREE types of PPE most commonly required with power, and or, hand tools
- A.
Safety Glasses
- B.
Hard Hat
- C.
Ear Defenders
- D.
Gloves
- E.
Shin Guards
- 14.What should you do if using an electric drill for a length of time?
- A.
Allow it to cool down every now and again
- B.
Make a weekly maintenance check
- C.
Oil it regularly
- 15.The vents of an electric drill should be cleaned by blowing compressed air into them
- A.
True
- B.
False
- 16.You should avoid wearing loose clothing when working with power tools?
- A.
True
- B.
False
Questions: 20 | Attempts: 242 | Last updated: Sep 12, 2014
-
Sample QuestionWhich of the list below are THREE of the main hazards present in the installation of windows and doors?
Questions: 19 | Attempts: 444 | Last updated: Mar 4, 2013
-
Sample QuestionThere are two different types of Office Directors.Identify one of them.
Questions: 21 | Attempts: 103 | Last updated: Sep 12, 2014
-
Sample QuestionTools should be left out at all times, so that they can be found easily
Back to top