Network+ TDR and OTDR Testing Methods Quiz

Submit

2. True or False: Both TDR and OTDR can detect faults in live, operating network cables without disruption.

True

False

Submit

4. Which scenario best demonstrates when to use OTDR over standard continuity testing?

Testing a short 10-meter Category 6 cable

Locating a fault in a 2-kilometer fiber optic run

Checking network switch ports

Verifying PoE delivery on a patch cable

5. True or False: OTDR testing requires both ends of the fiber to be accessible for accurate results.

True

False

Submit

7. What does a flat, sloping line in an OTDR trace indicate?

A cable break at that location

Normal fiber attenuation along the cable

A loose connector

An open circuit

Submit

9. True or False: OTDR can only be used on single-mode fiber and not on multimode fiber.

True

False

10. Which condition would show as a negative spike in an OTDR trace?

Fiber optic connector

Fiber optic splice

Cable break

All of the above

11. What does TDR stand for in network cable testing?

Time Domain Reflectometer

Transmission Data Relay

Topology Detection Router

Terminal Diagnostic Response

12. What is the primary purpose of using a cable tester with TDR capability?

To measure network latency

To identify cable faults and measure distance to breaks

To verify network speed and throughput

To detect unauthorized network access

13. True or False: TDR can accurately identify the exact location of a cable fault in twisted pair cabling.

True

False

Submit

15. Which of the following is an advantage of OTDR over TDR?

Works on both copper and fiber cables

Can test longer cable distances

Requires less expensive equipment

Faster testing procedure

Submit

17. In TDR testing, an open circuit in a cable produces what type of reflection?

Positive reflection

Negative reflection

Zero reflection

Neutral reflection

18. What does OTDR stand for?

Optical Transmission Data Relay

Optical Time Domain Reflectometer

Optimized Topology Detection Router

Optical Terminal Diagnostic Response

Submit

20. Which network medium is best tested using OTDR?

Category 6A twisted pair

Single-mode fiber optic cable

Coaxial cable

Shielded twisted pair

Network+ TDR and Fiber OTDR Testing Methods Quiz

1. In OTDR testing, attenuation is measured in ____.

2.

What first name or nickname would you like us to use?

2. True or False: Both TDR and OTDR can detect faults in live, operating network cables without disruption.

3. The ____ of a TDR pulse affects the resolution and range of fault detection.

4. Which scenario best demonstrates when to use OTDR over standard continuity testing?

5. True or False: OTDR testing requires both ends of the fiber to be accessible for accurate results.

6. In TDR testing, impedance ____ along the cable length can cause reflections.

7. What does a flat, sloping line in an OTDR trace indicate?

8. The velocity of propagation (NVP) in a TDR test accounts for the ____ at which a signal travels through the cable.

9. True or False: OTDR can only be used on single-mode fiber and not on multimode fiber.

10. Which condition would show as a negative spike in an OTDR trace?

11. What does TDR stand for in network cable testing?

12. What is the primary purpose of using a cable tester with TDR capability?

13. True or False: TDR can accurately identify the exact location of a cable fault in twisted pair cabling.

14. OTDR testing typically measures distance to a fault by calculating the speed of light in the ____ medium.

15. Which of the following is an advantage of OTDR over TDR?

16. A short circuit in a cable detected by TDR produces a ____ reflection.

17. In TDR testing, an open circuit in a cable produces what type of reflection?

18. What does OTDR stand for?

19. TDR works by sending an electrical pulse down a cable and measuring the ____.

20. Which network medium is best tested using OTDR?