Aruba Link Aggregation Certification Quiz

1. What is the primary advantage of using LAG in a network?

Reduced switch latency

Increased bandwidth and redundancy

Lower power consumption

Simplified VLAN configuration

2. True or False: LAG can be configured across non-adjacent ports on an Aruba switch.

True

False

3. What is the typical use case for static LAG configuration?

Connecting to non-LACP devices

Automatic failover scenarios

Dynamic port negotiation

Load balancing across VLANs

Submit

5. Which of the following is NOT a valid LACP mode on Aruba switches?

Active

Passive

Dynamic

Off

6. What does LACPDU stand for?

Link Aggregation Control Protocol Data Unit

Layer Access Control Protocol Definition Unit

Link Aggregation Configuration Protocol Data Unit

Local Aggregation Control Protocol Data Unit

7. True or False: LACP passive mode will respond to LACP requests but not initiate them.

True

False

8. What does LAG stand for in Aruba switching?

Link Aggregation Group

Layer Access Gateway

Local Area Gateway

Link Access Group

9. Which command enables LACP on an Aruba interface?

Lacp mode active

Aggregation mode on

Link aggregation enable

Port-channel mode desirable

10. True or False: All ports in a LAG must have identical speed and duplex settings.

True

False

11. LACP uses which UDP port for communication?

179

520

No specific UDP port

3306

12. What is the maximum number of ports in a single LAG on Aruba switches?

4

8

16

32

13. Which protocol dynamically negotiates link aggregation between switches?

LACP

LLDP

STP

RSTP

Submit

15. In Aruba switches, what is the default LACP timeout value?

30 seconds

90 seconds

120 seconds

60 seconds

16. Which hash algorithm uses source IP, destination IP, source port, and destination port?

L2 hash

L3 hash

L4 hash

IP-based hash

Submit

18. True or False: Ports in a LAG can have different VLAN configurations.

True

False

19. Which load balancing method uses source and destination MAC addresses?

L2 hash

L3 hash

L4 hash

Round-robin

Submit

Aruba Switching Associate Link Aggregation Quiz

1. What is the primary advantage of using LAG in a network?

2.

What first name or nickname would you like us to use?

2. True or False: LAG can be configured across non-adjacent ports on an Aruba switch.

3. What is the typical use case for static LAG configuration?

4. LACP heartbeat intervals can be configured as fast or ____ mode.

5. Which of the following is NOT a valid LACP mode on Aruba switches?

6. What does LACPDU stand for?

7. True or False: LACP passive mode will respond to LACP requests but not initiate them.

8. What does LAG stand for in Aruba switching?

9. Which command enables LACP on an Aruba interface?

10. True or False: All ports in a LAG must have identical speed and duplex settings.

11. LACP uses which UDP port for communication?

12. What is the maximum number of ports in a single LAG on Aruba switches?

13. Which protocol dynamically negotiates link aggregation between switches?

14. LACP mode 'active' means the port will ____ initiate LACP negotiation.

15. In Aruba switches, what is the default LACP timeout value?

16. Which hash algorithm uses source IP, destination IP, source port, and destination port?

17. On Aruba switches, the system priority in LACP is a ____ -bit value.

18. True or False: Ports in a LAG can have different VLAN configurations.

19. Which load balancing method uses source and destination MAC addresses?

20. Static LAG configuration does not require ____.