Document Change Control: Gas, Vault, AutoCAD, & Inventor
5 Questions
| Attempts: 442
These questions test the knowledge of LSI's Document Change Control: GAS, Vault, AutoCAD, & Inventor.
Questions and Answers
- 1.
If you are changing a BOM or drawing for a purchased or manufactured part, you must disposition material in which of the following locations (check all that apply):
- A.
Inventory
- B.
Discovery
- C.
Field
- D.
Open PO
Correct Answer(s)
A. Inventory
C. Field
D. Open PO -
- 2.
Grand Avenue Software (DCR) should be used when creating/revising the following document types?
- A.
Protocols and Reports
- B.
Drawings
- C.
IMs (Item Masters)
- D.
Both A and B
Correct Answer
D. Both A and B -
- 3.
When doing a search to assign a new document number for a Procedure what letter should be entered into the Document Number Field?
- A.
"R"
- B.
"P"
- C.
"D"
- D.
"B"
Correct Answer
C. "D" -
- 4.
When should collaboration tasks be used?
- A.
Collaboration tasks should always be utilized, except when collaboration is completed outside of GAS
- B.
Never
- C.
When collaboration is completed outside of GAS
- D.
None of the above
Correct Answer
A. Collaboration tasks should always be utilized, except when collaboration is completed outside of GAS -
- 5.
Drawings should be in the Approval-Production state in Vault when finalized and ready to be submitted for approval.
- A.
True
- B.
False
Correct Answer
A. True -
Quiz Review Timeline +
Our quizzes are rigorously reviewed, monitored and continuously updated by our expert board to maintain accuracy, relevance, and timeliness.
-
Current Version
-
Mar 21, 2022Quiz Edited by
ProProfs Editorial Team -
Mar 26, 2018Quiz Created by
Mick Snyder
Back to top