Noc Competency Test
The National Occupational Classification is a table with all the occupations in the Canadian labor market. The government prints it out as a book for the enlightenment of both employees and employers. All the best.
- 1.
Referring to the config applied on above EDD, what is the burstable rate allowed?
- A.
24.9 MB
- B.
25 MB
- C.
24.9 Mb
- D.
25 Mb
Correct Answer
D. 25 Mb -
- 2.
Customer has been provisioned a LES100 circuit. What is likely the service performance rate if above config is applied on the EDD?
- A.
The service will not work
- B.
The throughput is capped at 10Mb though the LES100 circuit is provisioned
- C.
The throughput is burstable to 100Mb provided the CIR/PIR for the LAN port is set to 100Mb
- D.
The service will work in intermittent manner
Correct Answer
A. The service will not work -
- 3.
Customer was complaining about very getting high upload speed and very low download speed (i.e - 80Mbps for Upload and 4Mbps for Download) from the speed test carried out from his local host. Referring to the above screenshot, what is likely to be the reason?
- A.
Duplex issue
- B.
The CIR and PIR is not matched
- C.
Dual COS has been disabled
- D.
Information given can't localise the issue
Correct Answer
A. Duplex issue -
- 4.
*VLAN 3768 - Configured to allow Internet service for the customerExponential-e delivered a Powerserve Internet service to customer with a managed EDD and CPE. The customer has connected the EDD to the NTE and CPE to the EDD. The customer tested the Internet service and confirmed that all is working fine.However, Exponential-e's NOC still not getting management to the CPE on-site. What is missing from the config?
- A.
Mgmt Tunnel [LAN-1] is not enabled
- B.
FID for CPE's management VLAN is not configured on the Mgmt Tunnel [LAN-1]
- C.
FID for CPE's management VLAN is not configured on the E100 [LAN-1]
- D.
FID for CPE's management VLAN is not configured on the E1000 [WAN]
Correct Answer
C. FID for CPE's management VLAN is not configured on the E100 [LAN-1] -
- 5.
What is/are function(s) of the EDD (ADVA) delivered to customers? (Choose all that apply)
- A.
Dumb device to provide only management and monitoring purposes through the SNMPc
- B.
Tagging traffic with VLANs for specific services before being passed to the MPLS network
- C.
Performing routing and switching for traffic originating from customer's LAN
- D.
The only platform that can allow VPLS technology run across the network from the customer's LAN
Correct Answer
B. Tagging traffic with VLANs for specific services before being passed to the MPLS network -
- 6.
Which ADVA is being used to terminate PowerAccess Lite (LTA) service? (Choose all that apply)
- A.
ADVA-825
- B.
ADVA-512
- C.
ADVA-814
- D.
ADVA-410
Correct Answer
B. ADVA-512 -
- 7.
Which ADVA is designed to have redundant Power Supply Unit?
- A.
ADVA-825
- B.
ADVA-512
- C.
ADVA-814
- D.
ADVA-410
Correct Answer
A. ADVA-825 -
- 8.
What is the cable need to be used by the customer to connect the EDD to the NTE and CPE?
- A.
Straight-through
- B.
Crossover
- C.
Rollover
- D.
Doesn't matter
Correct Answer
A. Straight-through -
Quiz Review Timeline +
Our quizzes are rigorously reviewed, monitored and continuously updated by our expert board to maintain accuracy, relevance, and timeliness.
-
Current Version
-
Mar 18, 2022Quiz Edited by
ProProfs Editorial Team -
Feb 07, 2009Quiz Created by
Manish.expo-e
- Aptitude Test Quizzes
- Course Test Quizzes
- Driving Test Quizzes
- English Test Quizzes
- FCAT Quizzes
- General Knowledge Quizzes
- Intelligence Test Quizzes
- Medical Test Quizzes
- Mock Test Quizzes
- Philosophy Test Quizzes
- Practice Test Quizzes
- Pretest Quizzes
- Safety Test Quizzes
- Skill Assessment Quizzes
- Spelling Test Quizzes
- Standardized Test Quizzes
Back to top