High Pressure Fuel Pump And Belts! Trivia Quiz
10 Questions
Settings
-
+
.
Questions and Answers
- 1.Q11 High Pressure Fuel Lines must be rigidly connected every ____ mm?
- A.
50mm
- B.
75mm
- C.
100mm
- D.
150mm
- 2.Q12 In FSAE Endurance Course, Constant turns have a diameter of ____ feet to ____ feet?
- A.
98.4-177.2ft
- B.
80.3-150.2ft
- C.
100-150ft
- D.
150-200ft
- 3.Q13 High Pressure fuel pumps must be shielded by using steel of ___ mm thickness?
- A.
1mm
- B.
2mm
- C.
3mm
- D.
5mm
- 4.Q14 If multiple base plates are used then what should be the min gap between them should be:
- A.
1/4 inch
- B.
1/8inch
- C.
1/16 inch
- D.
No limitation
- 5.Q15 All driver restraint systems must have what specification ?
- A.
SFI 16.1
- B.
FIA 8851/92
- C.
No such rule
- D.
None of these
- 6.Q16 what should be the min cross section area of steel to be used for harness tab if lap belts and anti submarine belts are attached to the same point?
- A.
90sq m
- B.
60sq m
- C.
0.093sq in
- D.
0.14sq in
- 7.Q17 The anchorage points should be approx. _______mm apart for a 6 point harness system?
- A.
25.4
- B.
50
- C.
75
- D.
100
- 8.Q18 Min thickness of roll bar padding is :
- A.
13m
- B.
13cm
- C.
13mm
- D.
No limitation
- 9.Q19 Diameter of engine inspection tool is :
- A.
3cm
- B.
1.4inch
- C.
3mm
- D.
No limitation
- 10.Q20 Normal aluminium lug nuts are used in a car, Will it violate any rule ?
- A.
Yes
- B.
No
- C.
May be
- D.
No violatoion
Back to top