Mtq 310 Assembly Paint #2

12 Questions

Settings
Please wait...
Mtq 310 Assembly Paint #2

Paint quiz for assembly


Questions and Answers
  • 1. 
    Employee must wear chemical resistant gloves while changing paint drums
    • A. 

      True

    • B. 

      False

  • 2. 
    Painted masking tape should be disposed of
    • A. 

      In the nearest garbage can

    • B. 

      By rolling it up and tossing it under a shelf

    • C. 

      In the solid paint waste drum

    • D. 

      Answer option 4

  • 3. 
    Viscosity test must always be completed upon startup of a new tote or drum and upon a long shut down period of greater than__________ hours
  • 4. 
    The target dry mil thickness should be between ____ and _____
    • A. 

      1 and 2

    • B. 

      3 and 4

    • C. 

      0 and 2

    • D. 

      1 and 4

  • 5. 
    Dry mil thickness should be checked:
    • A. 

      On whatever part of the product the paint happens to be in the target thickness range

    • B. 

      Only when you feel there may be a problem with the paint

    • C. 

      On all surfaces, with special attention to the axle seat areas and hard to reach corners

    • D. 

      On every part you paint

  • 6. 
    When applicable, ______ out of every 16 beams should be checked for proper undercoating coverage.  Verify 100% coverage inside of beam using a _____________
  • 7. 
    In order to measure paint drum viscosity, you need:
    • A. 

      A digital thermometer

    • B. 

      A Zahn viscosity cup

    • C. 

      A stopwatch

    • D. 

      All of the above

  • 8. 
    Should any of the aforementioned Inspectin and Quality requirements not be met, you should:
    • A. 

      Contact your supervisor

    • B. 

      Ignore the problem

    • C. 

      Keep going and document it in KBM

    • D. 

      Send all product from the last check back through the paint booth

  • 9. 
    Paint booth air-flow data collection must be performed no less than _____  times a day or any time the booth air-flow is in question.
  • 10. 
    The surface coating shall be free from runs and sags
    • A. 

      True

    • B. 

      False

  • 11. 
    What is MMFF663?
    • A. 

      Daily TPM Production Log

    • B. 

      Bystronic laser index

    • C. 

      Manufacturing form for second person paint verification

    • D. 

      None of the above

  • 12. 
    • A. 

      Hangers

    • B. 

      Uppers

    • C. 

      Axle Seat area of Beams

    • D. 

      Shock Clevis