Scrut Quiz 4
- 1.Which statement is false:
- A.
The Main Hoop must be constructed of a single piece of uncut, continuous, closed section steel tubing
- B.
In side view, no part of the Front Hoop can be inclined at more than twenty degrees (20°) from the vertical
- C.
Any non-permanent joint at either end of the roll hoop must be either a double-lug joint or a sleeved butt joint
- D.
Mounting plates welded to the Roll Hoop braces must be at least 2.4 mm thick steel
- 2.What is the minimum Young's Modulus (E) to be used when calculating for the SES?
- A.
200
- B.
205
- C.
210
- D.
215
- 3.What else will be scrutineered beside the car?
- A.
Driver equipment, fire extingusher and only rain tires
- B.
Driver equipment, team wear and rims
- C.
Driver equipment, fire extingusher(s) and all tires
- 4.What is the minimum Radii of Edges of Aerodynamic Devices?
- A.
1.5 mm for all wing edges including wings, end plates, Gurney flaps, wicker bills and undertrays that could contact a pedestrian
- B.
1.6 mm for all wing edges including wings, end plates, Gurney flaps, wicker bills and undertrays that could contact a pedestrian
- C.
1.4 mm for all wing edges including wings, end plates, Gurney flaps, wicker bills and undertrays that could contact a pedestrian
- D.
1.9 mm for all wing edges including wings, end plates, Gurney flaps, wicker bills and undertrays that could contact a pedestrian
- 5.What is the emergency phone number in Germany?
- A.
113
- B.
112
- C.
111
- D.
123
- 6.What happens if two team members (one of which is a driver) are tested with an alcohol level higher than 0.0 ‰ [per thousand] on the event site?
- A.
Only the driver will immediately be disqualified for the rest of the event
- B.
Twenty five points penalty
- C.
The entire team will immediately be disqualified for the rest of the event
- 7.Any items added or removed to the Cost Report through Addenda will be cost:
- A.
At the same price of the table cost
- B.
At 1.15 times the table cost when added and 0.85 times when removed
- C.
At 1.25 times the table cost when added and 0.75 times when removed
- D.
At 1.50 times the table cost when added and 0.50 times when removed
- 8.Enclosed monocoque structures, undertrays or skid plates designed to protect the engine or tanks carrying liquids must have at least 1 (one) hole with a minimum diameter of
- A.
50 mm
- B.
60 mm
- C.
70 mm
- D.
80 mm
- 9.Which statement about the transponder mounting is true?
- A.
The transponder must be mounted vertically and orientated so the number can be read "right-side up".
- B.
The transponder must be mounted on the driver's left side of the car forward of the front roll hoop.
- C.
The transponder must be no more than 70 cm above the track.
- D.
If the signal will be obstructed by metal or carbon fiber, a 12 cm diameter opening can be cut, the transponder mounted flush with the opening, and the opening covered with a material transparent to the signal.
- 10.The total energy absorbed by the impact attenuator must meet och exceed
- A.
7450 Joules
- B.
7150 Joules
- C.
7250 Joules
- D.
7350 Joules
Back to top