Shwet - 1 (FSC)
- 1.What would be the radius of a cylinder whose volume is same as the area of the cockpit internal cross section and with length of the cylinder is equal to the minimum wall thickness of the main hoop bracing supports?
- A.
6.11 inches
- B.
17.0434 cm
- C.
0.6908333 feet
- D.
None of the above
- 2.During the TI the inspector checks the cockpit. The inspector notices that the shoulder harness is welded onto an aluminium bracket and tab. He asks for the documentation for the same? Which of the following is true?
- A.
Inspector will check if the attachment can withstand a load of 6.5KN and if yes then rule compliant
- B.
Inspector will check if the distance between the attachments are less than 100mm, if yes then they should withstand a load of 13KN
- C.
Inspector will check if the harness attachments have been tested for worst case scenarios and the range of angles for the same
- D.
All of the above
- 3.During the endurance event, your vehicle goes on track and then has issues with ground clearance. The driver is shown a black flag with an orange dot. Which of the following is not false for this scenario
- A.
The team will receive a DQ
- B.
The team will receive a penalty of 10 seconds
- C.
Team will receive a penalty of 2 mins
- D.
None of the above
- 4.A team designs their lubrication system to be below the line joining main hoop and lowest chassis member behind the lubrication system and is protected by structure mounted on the firewall. Which of the following is true?
- A.
This is rule compliant will consideration
- B.
If documentation shown for the same it will be allowed
- C.
Non - rule compliant and will be rejected
- D.
All of the above
- 5.Your team is making the CBOM. They have added the following topics into the CBOM 1) Bought parts 2) R & D 3) Machining Rate 4) Development hour of team Which of the above is not needed
- A.
1 and 4 only
- B.
2 and 4 only
- C.
1 and 3 only
- D.
1, 2, 3 and 4
- 6.Your team submitted its TMD document 5 days after the deadline and the officials asked for correction in the document. The team submitted the document on the 10th day after the request. Which of the following will be true?
- A.
60 point penalty will be incurred by team
- B.
10 points penalty will be incurred by team
- C.
85 point penalty will be incurred by team
- D.
None of the above
- 7.A vehicle has no sensor but the team needs to check whether engine is running clean or rich. How will the team do the same.
- A.
Measuring water temp
- B.
Exhaust observation
- C.
Both
- D.
None
- 8.A sprinter can be considered a more POWER oriented engine or a more TORQUE producing engine at the latter end of the race?
- A.
Power oriented
- B.
Torque oriented
- C.
Both
- D.
Cannot be said
- 9.
Mark the true statement. We want instant power ( Take care of stability and as well as power as both of them will be acting as opposing forces when negotiating a turn. Consider this an SUV of high cg) Considering Turn 8 of this track- A.
Before the apex of a corner
- B.
After the apex of a corner
- C.
During the apex of a corner
- D.
None of the above
- 10.There is inline 4 cylinder and inline 5 and inline 6. What is the difference in bank angle if these engines ( keep every parameter except number of cylinders constant )
- A.
40
- B.
28
- C.
20
- D.
0
Recent Quizzes
Featured Quizzes
Back to top