Microsoft Networking

10 Questions | Total Attempts: 1026

SettingsSettingsSettings
Please wait...
Microsoft Networking

.


Questions and Answers
  • 1. 
    Which of the following regenerates a signal and broadcasts that signal to every computer connected to it?
    • A. 

      Hub

    • B. 

      Switch

    • C. 

      Router

    • D. 

      Firewall

  • 2. 
    Which one of the following is not a central connecting device?
    • A. 

      Hub

    • B. 

      Switch

    • C. 

      SOHO Router

    • D. 

      Windows 7 Client

  • 3. 
    You need to install a network adapter to a computer so that it can be connected to a network that uses twisted-pair cabling. What type of port does the network adapter need to use?
    • A. 

      RJ11

    • B. 

      RJ45

    • C. 

      RG58

    • D. 

      Fiber Optic

  • 4. 
    Where can you go in Windows 7 to access the properties of a network adapter?
    • A. 

      Device Manager

    • B. 

      Ping

    • C. 

      Advanced Firewall

    • D. 

      Task Manager

  • 5. 
    You need to connect a computer's network adapter to a switch. You want the connection to be able to send and receive data simultaneously. What type of connection do you need?
    • A. 

      Half Duplex

    • B. 

      Full Duplex

    • C. 

      Simplex

    • D. 

      100Mbps

  • 6. 
    You need to connect a computer at a rate of  100,000,000 bits per second. What speed network adapter should you install?
    • A. 

      10Mbps

    • B. 

      100 MB/s

    • C. 

      100 Mbps

    • D. 

      1000 Mbps

  • 7. 
    You need to connect to a router that has the IP address 192.168.1.100 on a standard, default Class C network using the subnet mask 255.255.255.0. Which of the following is a valid IP address for your network adapter?
    • A. 

      192.168.0.1

    • B. 

      192.168.1.1

    • C. 

      192.168.100.1

    • D. 

      192.168.1.100

  • 8. 
    You have just installed a network adapter and configured an IP address and subnet mask. What command can you use to verify that the IP address is configured and listed properly?
    • A. 

      Ping

    • B. 

      Tracert

    • C. 

      CMD

    • D. 

      IPConfig

  • 9. 
    You need to ping your own computer to see if it is alive. Which of the follwoing would qualify as command-line syntax to do so?
    • A. 

      Ping localclient

    • B. 

      Ping 128.0.0.1

    • C. 

      Ping loopback

    • D. 

      Ping network adapter

  • 10. 
    You have been instructed to connect a computer to a group of hosts that have been segmented from the regular network. What kind of network is this?
    • A. 

      LAN

    • B. 

      WLAN

    • C. 

      WAN

    • D. 

      VLAN