Drivers Education Quiz
In this quiz you will show whether you are able to meet the following declarative (knowledge) and procedural objectives:
Identify the components of an automobile dashboard with at least 80% accuracy Describe the function of each dashboard component with at least 80% accuracy Explain the road safety check process, meeting the criteria for a minimum score of 3 out of 4 on the Discussion rubric Identify common road signs with at least 90% accuracy Illustrate proper use of turn signals that meets the legal limits Demonstrate how to change a tire with 100% accuracy
- 1.
Which type of sign(s) are categorized as Regulation Signs?
- A.
![Drivers Education Quiz - Quiz]()
- B.
![Drivers Education Quiz - Quiz]()
- C.
Your town USA 25 Miles. . . . .
- D.
H
Correct Answer
A.Explanation
Regulation Signs are usually white rectangles with black lettering or symbols (sometimes they use red letters or symbols). hint they are regulating something such as your speed, turns, etc,
Warning Signs are yellow with black letters/symbols and are diamond shape. Hint: they are warning you of conditions ahead.
Destination signs are green with white letters and are showing distance and direction to a certain location.
Service signs are blue with white lettering showing different services ahead such as hospitals, restaurants, gas, rest area, etc.Rate this question:
-
- 2.
Identify the following dashboard indicator lights in the correct order:
- A.
Airbag system, out of gas, seat belt reminder, powertrain malfunction
- B.
ABS warning light, low fuel notification, seat belt reminder, electrical warning
- C.
ABS warning light, no gas needed, air bag malfunction, electrical warning
- D.
Airbag system, low fuel notification, seat belt reminder, powertrain malfunction
Correct Answer
B. ABS warning light, low fuel notification, seat belt reminder, electrical warningExplanation
ABS warning light, low fuel notification, seat belt reminder, electrical warning is the correct answer.
Airbag system is more specific with indicators for front (#10) and side (#11).
powertrain or engine malfunction will look like:
Rate this question:
-
- 3.
Check all that apply for indicator #33
- A.
High beam light
- B.
Temperature warning light
- C.
Oil pressure warning
- D.
It warns the driver of the possibility of engine overheating
- E.
The notification is activated once the driver pushes the emergency button
- F.
Usually demands the driver to stop the vehicle
Correct Answer(s)
B. Temperature warning light
D. It warns the driver of the possibility of engine overheating
F. Usually demands the driver to stop the vehicleExplanation
#33 is the Temperature Warning Light. It warns the driver about the engine possibly overheating and usually the driver should stop the vehicle.
High beam light is #35.
Oil pressure warning is #36.
The emergency button deals with the hazards (that symbol is a triangle inside a triangle).Rate this question:
-
- 4.
Below are different road safety check processes. Choose the safety check processes that deal with STOPPING.
- A.
Adjusts mirrors and seat
- B.
Checks traffic (sees and reacts to hazards).
- C.
Stops behind crosswalk or limit line.
- D.
Signals
- E.
Stops without using accelerator at the same time.
Correct Answer(s)
B. Checks traffic (sees and reacts to hazards).
C. Stops behind crosswalk or limit line.
E. Stops without using accelerator at the same time.Explanation
Checks traffic (sees and reacts to hazards), Stops behind crosswalk or limit line, Stops without using accelerator at the same time are correct.
Adjusting mirrors should be done before you start driving.
Signals are used for turning and changing lanes.Rate this question:
-
- 5.
You should always use your turn signal when you turn, change lanes or pass. What is the correct distance that you should put your turn signal on?
- A.
100 feet
- B.
100 meters
- C.
100 yards
- D.
50 feet
Correct Answer
A. 100 feetExplanation
100 feet is correct. The is a little more than 3 feet in 1 meter so that is too large, as well as 3 feet in 1 yard.
50 feet is not enough of a warning.Rate this question:
-
- 6.
After you pull over to a safe spot and turn on your hazards, the correct order of steps when changing a flat tire are as follows:
- A.
Use the wrench to loosen the lug nuts, Remove the lug nuts and pull the tire off the car, Use the jack to lift the vehicle off the ground, Place the spare on the car, Put on the lug nuts, Lower the car back to the ground, Make sure the lug nuts are tightened, Put your flat tire and tools back in your trunk.
- B.
Make sure the lug nuts are tightened, Use the jack to lift the vehicle off the ground, Remove the lug nuts and pull the tire off the car, Place the spare on the car, Put on the lug nuts, Lower the car back to the ground, Use the wrench to loosen the lug nuts, Put your flat tire and tools back in your trunk.
- C.
Use the wrench to loosen the lug nuts, Use the jack to lift the vehicle off the ground, Remove the lug nuts and pull the tire off the car, Place the spare on the car, Put on the lug nuts, Lower the car back to the ground, Make sure the lug nuts are tightened, Put your flat tire and tools back in your trunk.
- D.
Use the jack to lift the vehicle off the ground, Use the wrench to loosen the lug nuts, Remove the lug nuts and pull the tire off the car, Place the spare on the car, Put on the lug nuts, Lower the car back to the ground, Make sure the lug nuts are tightened, Put your flat tire and tools back in your trunk.
Correct Answer
C. Use the wrench to loosen the lug nuts, Use the jack to lift the vehicle off the ground, Remove the lug nuts and pull the tire off the car, Place the spare on the car, Put on the lug nuts, Lower the car back to the ground, Make sure the lug nuts are tightened, Put your flat tire and tools back in your trunk.Explanation
The first choice is not correct because after you loosen the lug nuts you lift the car up with the jack, then continue to take off lug nuts.
The second choice is not correct because you want to initially loosen the lug nuts before you lift the car off the ground, then tighten when you are done.
The third choice is correct!
The forth choice is not correct because should only loosen the lug nuts before you lift the car.Rate this question:
-
Quiz Review Timeline +
Our quizzes are rigorously reviewed, monitored and continuously updated by our expert board to maintain accuracy, relevance, and timeliness.
-
Current Version
-
Feb 05, 2013Quiz Edited by
ProProfs Editorial Team -
Dec 04, 2011Quiz Created by
Cbutterfield13
Back to top