# Dimensions And Tolerances 10-1

17 Questions | Total Attempts: 18  Settings  10-1

Related Topics
• 1.
What shows the length, height, and width of objects?
• A.

Angular dimensions

• B.

Degree dimensions

• C.

General dimensions

• D.

Linear dimensions

• 2.
What is the symbol for diameter? GRAPHICS NEEDED (D)
• A.

A

• B.

TYP

• C.

C

• D.

D

• 3.
Where do general drawing tolerances apply?
• A.

When PLs, MPLs, and PSDLs are indicated by the picture sheet

• B.

Where dimensions are assigned to specific zones of a drawing

• C.

Where dimensions are specified on the picture sheet and indicated by a view

• D.

Where dimensions are not otherwise specified in the drawing

• 4.
What type of tolerance is in the notes area to the left of the title block of the picture sheet?
• A.

General drawing tolerances

• B.

Point tables

• C.

Revised tolerances

• D.

Specific drawing tolerances

• 5.
What is shown on only one view of a picture sheet, even if the object or feature itself is shown in more than one view?
• A.

Dimensions of that object or feature

• B.

Scale of an object or feature

• C.

Tolerances of the drawing

• D.

Units of measurement for the features

• 6.
What type of dimension starts at a single dimension line and arrow lollowed by several, separate ending dimension lines and arrows?
• A.

Equally spaced

• B.

General drawing

• C.

Progressive

• D.

Reference

• 7.
How will you know if a dimension is typical?
• A.

REF

• B.

REP

• C.

TYP

• D.

TYPICAL DIM

• 8.
How are all holes on Boeing drawings measured?
• A.

Circumference

• B.

Diameter

• C.

Feet

• D.

• 9.
At Boeing, inches are the standard unit of measurement for linear dimensions?
• A.

True

• B.

False

• 10.
A reference dimension is authoritive
• A.

True

• B.

False

• 11.
Flange dimensions are taken from the edge of the flange to the outside mold line?
• A.

True

• B.

False

• 12.
What are internal arcs?
• A.

Bevels

• B.

Fillets

• C.

• D.

Rounds

• 13.
How do we measure fillets and rounds?
• A.

Degrees

• B.

Inside

• C.

Outside

• D.

• 14.
All angular measurements on a drawing are shown as:
• A.

Angles

• B.

Arcs

• C.

Defaults

• D.

Degrees

• 15.
What type of measurement is preceded or followed by an R?
• A.

• B.

Right

• C.

Rotation

• D.

Round

• 16.
What do angular measurements tell you
• A.

Amount of rotation

• B.

Diameter

• C.

Height, length, and width

• D.

• 17.
What are the units of measurement for rotation?
• A.

Degrees

• B.

Inches

• C.

Millimeters

• D.