Breath Alcohol- Unit 4-conducting A Screening Test

9 Questions | Total Attempts: 148

SettingsSettingsSettings
Please wait...
Breathing Quizzes & Trivia

**Your results for these unit quizzes are not saved so please be sure to enter your name at the beginning of each quiz and print the certificate screen when your grade is displayed. Give your certificate to your trainer. **


Questions and Answers
  • 1. 
    Type Full Name Below
  • 2. 
    What screening result would warrant a confirmation test be conducted?
    • A. 

      Any result above 0.000

    • B. 

      Any result below 0.020

    • C. 

      Results of 0.020 or greater

    • D. 

      Any result above 0.020 but not including 0.020

  • 3. 
    What step needs taken to complete a screening test where the Breathalyzer provides a printed result but does not print directly on the ATF (Alcohol Testing Form)?
    • A. 

      Handwrite the results on the ATF

    • B. 

      Attach the results to the ATF in the designated area using scotch tape

    • C. 

      Attach the results to the ATF in the designated area using tamper evident tape

    • D. 

      No special action needed.

  • 4. 
    If the breathalyzer works but does not meet the requirements of a confirmation test, what must be done to complete a screening test? (Check all that apply)
    • A. 

      Hand write the results on the ATF in the designated area.

    • B. 

      Hand write the Manufacturer name and serial number for the device on teh ATF

    • C. 

      If the results warrant a confirmation test, refer the employee to another facility where they can obtain a confirmation test within 15-30 minutes.

    • D. 

      Contact the employer and note in the remarks section that your device will not be acceptable for a confirmation test and that you must refer them to another facility, noting who you spoke to and when.

    • E. 

      Do not complete any testing- turn them away.

  • 5. 
    You have completed a positive screening test and the results shown on the breathalyzer display do not match the results that printed. What do you do?
    • A. 

      Cancel the test and start over with a new Breathalyzer (noting all steps in the remarks)

    • B. 

      Cancel the test and send the employee away.

    • C. 

      Ignore the mismatch and just tape the print out results to the ATF

    • D. 

      Call my supervisor

  • 6. 
    Which statement below best demonstrates what should be said to an employer  to instruct him/her on how to provide a breath sample?
    • A. 

      Blow into the mouthpiece here.

    • B. 

      Take a deep breath and blow forcefully into the mouthpiece for at least 6 seconds or until the green light goes out and horn stops sounding.

    • C. 

      Blow six short puffs into the mouthpiece.

    • D. 

      Blow until I tell you to stop

  • 7. 
    When must you affix the printed result to the ATF?
    • A. 

      When the EBT does not print the results on the ATF directly

    • B. 

      When the printer runs out of ink

    • C. 

      Never

    • D. 

      Only when directed by my supervisor

  • 8. 
    Under what circumstances might you have to write in the remarks section of the ATF? (Check all that apply)
    • A. 

      Never

    • B. 

      When the employee refuses to sign step 2 of the ATF

    • C. 

      When the unique test number displayed on the EBT does not match the unique test number on the printed results.

    • D. 

      When you call the employer for testing clarification

    • E. 

      When the printed results does not match the displayed results

    • F. 

      When a test must be canceled, I need to document the circumstances behind the cancelation and the corrective action taken.

    • G. 

      When the employee refuses to sign step #4 of the ATF

Related Topics
Back to Top Back to top