Fsr Reg Quiz 12 (rahul)
10 Questions
Settings
-
+
Questions and Answers
- 1.What is the point penalty for late submission of a fuel type order?
- A.
50 points
- B.
20 points
- C.
25 points
- D.
No penalty
- 2.What should be the minimum distance between the throttle cable and any exhaust component?
- A.
50.89 mm
- B.
30 mm
- C.
3 inches
- D.
25.4 mm
- 3.What is the maximum restrictor diameter foe E-85 fueled cars?
- A.
20mm
- B.
19.8mm
- C.
19 mm
- D.
18mm
- 4.What is the distance below the top of the sight tube between which the permanent, non-moveable fuel level line must be located?
- A.
12.7mm and 50.8mm
- B.
6.25mm and 12.5mm
- C.
12.7 mm and 25.4mm
- D.
25.4mm and 50.8mm
- 5.During the noise test, at what distance will the measurements be made with a free field microphone at the exhaust level from the end of the exhaust outlet?
- A.
19.68 inches
- B.
17.7 inches
- C.
23.6 inches
- D.
60 cm
- 6.An “industrial engine” is defined as an engine which, according to the manufacturers’ specifications and without the required restrictor, is not capable of producing more than _________ ?
- A.
6hp per 100 cc
- B.
7hp per 130 cc
- C.
4hp per 100 cc
- D.
None of the above
- 7.What is the space that must be made available for the technical inspection sticker which will be placed on the nose of the car directly in front of the cockpit opening?
- A.
6" tall and 3" wide
- B.
4" tall and 7" wide
- C.
3" tall and 6" wide
- D.
3" tall and 7" wide
- 8.Rennteam Uni Stuttgart's car weighed 214kg prior to the Engineering Design judging. Later during the dynamic competition, it was found to be weighing 224.4kg. What is the point penalty that will be given in this case?
- A.
100 points
- B.
140 points
- C.
190 points
- D.
120 points
- 9.In the side view of the vehicle, the portion of the Main Roll Hoop that lies above its attachment point to the Major Structure of the Frame must be within what angle of the vertical?
- A.
30 degrees
- B.
45 degrees
- C.
10 degrees
- D.
12 degrees
- 10.The minimum yield strength for bending and buckling strength calculations in a SES is?
- A.
43.5 ksi
- B.
44.2 ksi
- C.
26 ksi
- D.
52.9 ksi
Back to top