Topics
Products
Follow Us:

Engineering Questions and Answers (Q&A)

John Adney
Answered: Oct 04, 2017

Most texts and the standard identify the tolerance zone for circularity as two coaxial circles.

2 Answers

C. Marcus, Content Developer
Answered: Oct 11, 2018
Option C is the right answer.
A wrench uses wheel and axle as simple machine to turn a bolt. The wrench and bolt act as wheel and axle. As rhe wrench spins around the bolt, it turns the...Read More

2 Answers

Susan Vatcher
Answered: Sep 19, 2017

I thought insufficient penetration was a welding discontinuity but apparently wrong!

2 Answers

D. gray, Builder
Answered: Feb 26, 2019
The correct answer to this question is D. Fiber saturation point is used to denote the point in the drying process in wood that only water in the cell walls will remain. It is the minimum...Read More

1 Answer

John Adney
Answered: Jun 17, 2017
Tensile strength s a more accurate term for testing of material.

1 Answer

Curt Pawloski
Answered: Oct 04, 2017

Most texts and the standard defines the circularity tolerancs as two coaxial circles.

1 Answer

John Adney
Answered: Oct 16, 2017

C'mon John, we need more than that. This isnt helpful

1 Answer

A. Cook, English Professor
Answered: Jan 25, 2019
This is very much the case. The reason is because a sharp chisel is going to take less time to use. It’s like a knife. When a knife gets blunt, it doesn’t cut. It rips and tears....Read More

1 Answer

H. callum, Content Writer
Answered: May 10, 2019
The ingot is usually seen in metal place because it is a block or some other shape that is made of metal and shaped into an object. Stringers are known as the fine lines that are likely to occur...Read More

1 Answer

Nzube.eleigwe
Answered: Feb 18, 2017
Work Breakdown Structure

1 Answer

Ejaz
Answered: Jun 13, 2019

Aeronauticalquestions are best because I would like to work in ot any thoughts

1 Answer

Galoxa
Answered: Nov 28, 2016
Improve access to stakeholders. - Correct Answer, no such improvement opportunity inBABOK 6.3.5.5

1 Answer

John Adney
Answered: Jan 21, 2017
The process is normally limited to the flat or horizontal-fillet welding positions NOT VERTICAL

1 Answer

John Adney
Answered: Nov 27, 2017
It depends on the cooling rate also but aheavy casting cooled under normal conditionsshouldhave a course grain structure that is softer and more ductile that a fine grain structure in the core....Read More

1 Answer

Loading, please wait...

Email Sent
We have sent an email to your address "" with instructions to reset your password.