20 questions you should expect on an A+ exam.
Client Microsoft network
Netbios
File and printer sharing
Appletalk protocol
Tcp/ip protocol
The systems registry should have been save prior to the installation of a device driver by using the system restore application.
The last known good configuration only works for hardware devices and any software applications are not applicable.
The system's registry is overwritten after every login and the settings on the initial install were overwritten after the first reboot and login.
The last known good configuration could not find a valid restore point since the system restore was not run prior to the installation of the device driver.
All of the above.
Verify that the NIC is enabled in the BIOS
Ensure that the NIC is seated correctly
Ensure that the driver is up to date
Check whether the computer boots and windows starts correctly
DNS
DHCP
APIPA
IPCONFIG
Internet Protocol Configuration
An 80 pin ribbon cable
A 40 pin ribbon cable
A 34 pin ribbon cable
A 6 pin round cable
Spyware remover
Popup blocker
Active X control
FTP service
Reset RAM
Clear the Motherboard
Reset the BIOS chip
Clear the CMOS jumper
FAT32
EFS
CDFS
NTFS
Configure a Remote Access Service (RAS) then use a dial up modem to access the internet.
Deploy a fiber cable connection to the new location.
Install and configure a wireless network.
Patch two Ethernet cables together with a repeater.
Change the name of the default router
Enable WPA
Turn on encryption
Disable SSID broadcast
Bluetooth
Infared
Ping
IEEE 1394/Firewire
Telnet
Right click on desktop > Properties > Settings > Advanced > Adapter > Properties > Driver
Start > Control Panel > Monitor > Advanced > Adapters > Properties > Driver
Right click my computer > Properties > Select device manager tab > Properties > Drivers
Default gateway address
SSID
WEP or WPA encryption
IP address
USB thumb drive
CD-ROM
Floppy drive
Hard drive
Add/Remove Window Components
Set Program Access and Defaults
Change or Remove Programs
Add New Programs
Mercury
Copper
Gold
Glass
Turn on the cable modem, then the router, and then the computer.
Turn on the cable modem, then the computer, and then the router.
Turn on the router, then the computer, and then the cable modem.
Turn on the computer, then the cable modem, and then the router.
The order doesn't matter.
Print the test page.
Print a blank sheet of paper.
Print the printer's IP address.
Reboot the computer.
Desktops with certain chipsets.
Compatibility with some windows NT4 applications.
Computers with scanners.
For SCSI devices.
Format and reload the Operating System.
Run Anti-Virus Software.
Delete cookies and temporary Internet files.
Update the BIOS regularly.
Run SCANDISK and DEFRAG
Quiz Review Timeline +
Our quizzes are rigorously reviewed, monitored and continuously updated by our expert board to maintain accuracy, relevance, and timeliness.
Wait!
Here's an interesting quiz for you.