1 reply to this topic

[NightWing310]

Ive been trying to make a topology with packet tracer 4.1. All i wanted was 2 LANS, 1WAN. I thought i configured all the IP addresses and subnets rights, but i guess  not. I know that the Routers for the WAN should be serial, but i cant Ping a computer on the other LAN

I attached the file

Attached Files

•  Simple_Packet_Tracer.zip   4.05K   516 downloads

Edited by NightWing310, 20 February 2008 - 09:10 PM.

[aravind86m]

 Simple_corrected_.zip   4.7K   216 downloads

Hi,
There are Lots of mistakes in the configuration, as follows:
(1)
Router 0
interface Serial2/0
ip address 192.111.123.1 255.255.255.0
clock rate 4000000

Router 1
interface Serial2/0
ip address 192.182.134.5 255.255.255.0

Both does NOT belong to same network.  

(2)
No routes are there in Router 0 to identify LAN behind Router 1.

(3)
No need of RIP if going for static routing, also it is configured wrongly in Router 1 instead of Router 0 (if required). Both the routers should run RIP (if configured) with their respective LANs being advertised but NOT the remote network.

Pls correct all these and verify !!!  ELSE i ve uploaded the correct version pls check !!!