+
Related Flashcards
Related Topics
Cards In This Set
| Front | Back |
 How should the FastEthernet0/1 ports on the 2950 model switches that are shown in the exhibit be configured to allow connectivity between all devices? |
SwitchX(config)# interface fastethernet 0/1
SwitchX(config-if)# switchport mode trunk
|
 Which two statements are true about interVLAN routing in the topology that is shown in the exhibit? |
The FastEthernet 0/0 interface on Router1 must be configured with subinterfaces.
The FastEthernet 0/0 interface on Router1 and Switch2 trunk ports must be configured using the same encapsulation type. |
|
A department decides to replace its hub with a Catalyst 2950 switch that is no longer needed by
another department. To prepare the switch for installation, the network administrator has erased
the startup configuration and reloaded the switch. However, PCs that are connected to the switch
experience various connectivity problems. What is a possible cause of the problem?
|
The VLAN database was not erased.
|
 Why has this switch not been elected the root bridge for VLAN1? |
It has a higher bridge ID than the elected root bridge.
|
 The following commands are executed on interface fa0/1 of 2950Switch. 2950Switch(config-if)# switchport port-security 2950Switch(config-if)# switchport port-security mac-address sticky 2950Switch(config-if)# switchport port-security maximum 1 The Ethernet frame that is shown arrives on interface fa0/1. What two functions will occur when this frame is received by 2950Switch? |
Only host A will be allowed to transmit frames on fa0/1.
All frames arriving on 2950Switch with a destination of 0000.00aa.aaaa will be forwarded out fa0/1. |
|
Interactive configuration dialog
|
Setup mode
|
|
Provides access to all other router commands
|
Privileged EXEC mode
|
|
Commands that affect interfaces/process only
|
Specific configuration modes
|
|
Commands that affect the entire system
|
Global configuration mode
|
|
Limited to basic monitoring commands
|
User EXEC mode
|
