Florida State Board Cosmetoloy Review Part 2 (Angel)

102 cards

Diffrent


 
  
Created Feb 26, 2012
by
ar56088

 

 
Table View
 
Download
 
Print

Flashcard Set Preview

  Side A   Side B
1
In discussing a hair cut, where is the perimeter located?
 
At the outer edges
2
It is recommened that you cut extremely currly hair
 
Dry cut before straightening
3
It is recommended that you cut kinky curly hair
 
dry after straightening
4
When cutting extremely curly hair, avoid which of the following cutting imlpements?
 
Razors
5
When cutting a "cowlicks", what tension should be used
 
No tension
6
When cutting hair with electric clippers, the hair should be
 
dry
7
When cutting the hair with a razor, the hair should be
 
Wet or damp
8
The reason razor cutting requires damp hair is
 
to avoid pulling the hair
9
The principal reason for using thinning shears is
 
Decrease bulk
10
Tapering has many different names,  name them 
 
Shingling,graduation,fading
11
Layering means the hair lenghts have been cut
 
Graduated
12
What  thin out hair?
 
Thinning shears, razors, shears
13
Which of the following is a part of the cutting shears?
 
finger brace,screw, blade
14
On which part of your cutting shears does your little finger rest
 
finger brace/guard
15
Which of the following can be acheive with the "shear over comb" technique
 
Layering very close to the skin
16
Type of haircut most suitable for client with a large chin or prominent jaw line?
 
chin length BOB
17
In cutting very straight hair, what degree of tension is reccommended?
 
Maximum tension
18
A client has fine, dense hair, and wants it thinned out. How far from the head, should the...
 
1 inch
19
Club cutting is a method of cutting the hair
 
Blunt and straight across
20
To create the apperance of height, cut the hair
 
Close at the nape and high in the crown
21
When trying to create more body in fine hair
 
Give a blunt cut
22
In razor cutting, the amount of hair removed in one razor stroke is dependant upon
 
Angle of the razor
23
When slithering hair, the best results will be obtained when using shears with which edge
 
Sharp
24
Flexible comb, used in a "scissors over comb" techique, creates a close/tight neckline is
 
Barber comb
25
Which of the following hair cutting implements may be used on wet or dry hair?
 
Shears
26
Which of the following hair cutting implements could be used on dry hair
 
Razor and shears
27
Which of the following hair cutting implements is best used on wet/damp hair
 
Razor
28
These hair-cutting lines are used to create a sense of weight and stability
 
Horizontal
29
These hair-cutting lines are used to create a sense/illusion of movement
 
Diagonal
30
The angle/degree at which you hold the hair out from the scalp prior to cutting
 
Elevation
31
A blunt cut, tends to create lines that are
 
hard
32
In the "shear over comb" cutting technique, which comb is generally used?
 
barber comb
33
In the "shears over comb" technique, you should work with an area
 
No wider than the comb
34
In the "shears over comb" tecnique, the angle of the comb will determine
 
The lenght of the hair
35
In the "shears over comb" technique, the stylist should begin the haircut at the
 
Nape
36
If your client has lice, what must you do?
 
Refuse service
37
When cutting the hair with clippers, it generally best to
 
Go against direction of the hair growth pattern
38
When using the "clipper over comb" technique, the clippers move
 
Sideways across top of the comb
39
While cutting a client's hair, if the stylist momentarily stops cutting, what is the best method...
 
palm them, closed, facing the stylist
40
Thinning shears are used to
 
remove excess bulk
41
Using "single-notched" shears will have which of the following effects
 
Remove more hair than double -notched
42
Using "doubled-notched" shears will have which of thfollowing effect
 
Remove less than single-notched
43
A uniformed layered cut (same lenght throughout) is cut at what angle/degree
 
90
44
A haircut using a 0 degree/angle is referred to as
 
Blunt cut, bob, solid form
45
Slithering/ effilating refers to the technique of decreasing bulk by
 
thinning the hair, opening & partially closing shears up and down the hair shaft
46
The technical/medical term for the palm of your hand
 
metacarpus
47
There are ___ bones in the metacarpus
 
5
48
This is the largest artery in the body
 
Aorta
49
There are ___ bones in the wrist/ carpus
 
8
50
"Fringe" is another term for "bangs" and is generally used to cover the area from
 
Outer corners of the eyes
51
When cutting hair with electric clippers, the hair should be
 
dry
52
The neutralizer used in a permanent wave solution/chemical hair relaxer is
 
Acid
53
The reason razor cutting require wet hair is
 
To avoid pulling the hair
54
A haircut using a 180 angle will have which of the following lengths
 
shorter interior, longer exterior
55
Tapering has many diffrent names, which of the following is not a name for tapering
 
blunt
56
The proper position for the shampoo cape while shampooing a client hair is
 
Over the chair
57
For what type of skin are facial scrubs contra-indicated (not advisable)?
 
acneic
58
When the palms of the hands/finger tips are used in rubbing motion, this is called
 
Friction
59
Using "single-notched" shears will have which of the following effects
 
Remove less hair then the double- notched
60
Which of the following will remove the greatest amount of hair
 
Regular shears
61
The approximate pH of permanent wave neutralizer is?
 
3-5
62
Which of the following would likely need to be melted prior to use
 
wax
63
Paraffin is
 
64
You have lightened your client's hair from level 3 to level 6, what is the underlying exposed...
 
 Orange/blue
65
You hae lightened your client's hair from 5 to a level 9, what is the underlying exposed warm...
 
Yellow /violet
66
You have lightened your client's hair from 5 to level 9, you then apply a blue based toner,...
 
green
67
In the "scissors over comb" technique, holding comb flat against the head will result in
 
less scalp visibility/longer hair
68
Silking, refers to
 
relaxing the hair with heat
69
The approximate pH of an ammonium thioglycolate solutionis
 
8.2-9.6
70
About 90% of the scalp hair is in this stage/phase at any given time
 
Anagen
71
About 10% of the scalp hair is in this stage/phase at any given time
 
Telogen
72
Although vellus and lanugo hair similar, vellus hair can be distinguished because
 
Vellus hair has no pigment
73
Which of the following is not a name for graduation in a haircut
 
Blunt
74
The hair that we are primarily concerned with cutting, is referred to as
 
terminal hair
75
Hair cut on an "Angle" is also referred to as being cut
 
On a Bias
76
Which of the following design lines would be used to add weight/build weight line?
 
Horizontal lines
77
Lanugo hair can be easily distinguised from Vellus hair because
 
lanugo hair has no pigment
78
The primary distinction between Vellus and Lanugo hair is
 
Lanugo hair has pigment vellus does not
79
Which of the following can be achieved with the "shears over comb" technique?
 
Layering the nape very close to the skin
80
Which type of haircut could be used to disguise a large chin and/or prominent jaw line?
 
chin lenght bob
81
When clipper cutting hair, the clippers should be held in what relationship to the comb
 
In the same position as the comb
82
This is the widest portion of the head, sometimes reffered to as the "crest area"
 
Parietial
83
The angle at which the fingers are held during a hair cut
 
cutting line
84
In haircutting, elevation is used to create
 
Graduation
85
When cutting a BOB
 
Palm Down
86
The most commonly used elevations in haircutting are
 
45% degree and 90% degree
87
An angle below 90% degree, is used primary to
 
build weight
88
Angle above 90% degree are used, is used primary
 
remove weight
89
The approximate pH of cold wave is
 
8.2 - 9.6
90
A" Blunt Cut", is sometimes referred to as/as a
 
BOB, One length/Solid Form, zero degree/elevation
91
In hair cutting, the are above the parietal/crest is crest is referred to as the
 
Interior
92
In hair cutting, the area below the parietal/crest is referred to as the
 
exterior
93
In a haircut, vertical line will do all of the following
 
Be used with higher elevation, remove weigh, used in graduated or layer cuts
94
Diagonal lines may be used ina haircut to accomplish 
 
Blend short layers to long layer, create beveling, create slanting/slopping lines
95
Beveling is a hair cutting technique used to create
 
Fullness by cutting the ends at a slight taper
96
All of the following are true about guidelines
 
There are two basic guideline,stationary and traveling,may be located at the interor or exterior...
97
Which is not an intended cnsequence of using horizontal lines in haircutting
 
The removal of weight
98
If your client wanted longer layer, what angles/degrees would you correctly use
 
A combination of 45% and 90% degree
99
In a graduated or layered haircut, the most commonly used elevation
 
45 degree
100
The most commonly observed elevation in a graduated haircut is
 
45 degree
101
Which angles/degree would create the longest possible layers in a clients haircut?
 
180 degree
102
Which angles/degree would provide the most movement and volume
 
180 degree


Upgrade and get a lot more done!
Upgrade    Cancel