+
Related Flashcards
Cards In This Set
| Front | Back |
|
What command is used to display the routing table?
|
Show ip route
|
|
What is the default subnet notation for the network listed in the show ip route command?
|
Prefix notation
|
|
What is the command to change the subnet notation to subnet masks in the output of show ip route?
|
Terminal ip netmask-format decimal
|
|
What command provides a summary of all interfaces and their IP addresses?
|
Show ip interface brief
|
|
What command provides a detailed view of the IP parameter settings per interface.
|
Show ip interface [interface type & number]
|
|
What command lists the interface IP address along with the interface statistics?
|
Show interfaces [interface type & number]
|
|
Which command displays the encapsulation being used?
|
Show interfaces [interface type & number]
|
|
What are 3 reasons why the status for serial interface 0 would state "Serial0 is up, line protocol is down"?
|
Clock rate is not set,
mismatching encapsulation types,
no keepalives
|
|
How do you set the bandwidth of serial0 to 64000bps?
|
Router(config-if)# bandwidth 64
The value for bandwidth is entered in kbps.
|
|
Which is a sure way of testing that TCP is working on your router?
|
Telnet to the router.
|
|
Name 2 important things to remember when using debug commands.
|
1. Debug output takes priority over other network traffic 2. Debug commands can severely affect performance.
|
|
Which command indicates who has telnet session to your router?
|
Router# show user
|
|
What 2 commands indicates how many telnet sessions are running from your router?
|
Router# show sessions or
Router# where
|
|
How can you turn CDP off for a specific interface?
|
Router(config-if)# no cdp enable
|
|
How can you turn CDP off for the entire router?
|
Router# no cdp run
|
