|
The following online study guide is designed to help you with your Comptia A+ test prep. You can discuss any questions or comments that you may have, either on these study guides or on the Comptia A+ test on our community forum.
|
 |
Display Assembly |
- Follow the instructions as indicated in the lesson titled 'Procedure and Guidelines' - PREWORK.
- Remove the keyboard.
- Open the display assembly approximately 180 degrees, and support the display assembly so that it does not open past this position.
- Loosen the captive screw that secures the display cable to the system board, and release the cable from the four cable-routing clips.
- Pull up on the pull-tab that is attached to the display cable connector to remove the connector from the system board.
- Remove the three M2.5 x 6-mm screws.
- Rotate the display assembly to a 90-degree angle, and lift the display assembly up and out of the computer base.
|
|
|
|
|
|
|
