- Follow the instructions as indicated in the lesson titled 'Procedure and Guidelines' - PREWORK.
- Turn the computer, right-side up and open it.
- Remove the Center Control Cover:
- Open the display all the way (180 degrees) so that it lies flat against your work surface.
- Starting on the right side of the computer, use a plastic scribe to pry up the Center Control Cover. Lift it away from the computer, and lay it aside.
- Remove the keyboard:
- Remove the two M2.5 x 6-mm screws across the top of the keyboard.
- Rotate the keyboard up and slide it forward.
- Hold the keyboard up and slightly forward to allow access to the keyboard connector.
- Pull up on the keyboard connector tab to disconnect the keyboard connector from the system board.
