|
 |
A+ Test Prep Tutorials |
|
|
|
|
Installing a CD/DVD Drive |
- Follow the instructions in caution and guidelines.
- Open the cover.
- Lay the computer on its side so that the system board is on the bottom of the inside of the computer.
- If you are installing a new drive, unpack the drive and prepare it for installation.
Check the documentation that accompanied the drive to verify that the drive is configured for your computer. If you are installing an IDE drive, configure the drive for the cable select setting.
- Connect the new drive to the set of rails that are attached to the inside of the cover.
- Attach the bracket to the new drive by aligning the screw holes on the drive with the screw holes on the bracket rails and then inserting and tightening all four screws (two screws on each rail).
- Gently slide the drive into place until the tabs securely click into position.
- Connect the power and data cables to the drive.
- Close the cover.
|
|
|
|
|
|
|
|
|
|
|
|
