You are here:

CompTIA Home

A+ Certification

Study Guide

Active Membership

Practice Questions

Practice Exams

Tutorials & Tips

Cram Sheets

A+ WebSchool

A+ Flashcards

A+ Quiz School

A+ Book Deals

Deals On Ebay

SAT Test

CompTIA A Plus Study Guide: Installing Windows

Contents

Quick Jump To Module

Lesson 1: Introduction

Lesson 2: Pre-assessment

Lesson 3: Hardware Compatibility and Minimum Requirements

Hardware compatibility and minimum requirements

Lesson 4: Disk Preparation

Disk Preparation | Partition | Format Drive

Lesson 5: Installation Method

Installation Method | Bootable CD

Lesson 6: Setup Utility

Installing Operating System | Installing Windows 98 | Installing Windows 2000 Professional

Lesson 7: Installation Options

Installation Options | Installation type (Typical/Custom) | Network Configuration | File System | Dual Boot Support

Lesson 8: Device Driver Configuration

Device Driver Configuration

Lesson 9: Operating System Upgrade

Operating System Upgrade | Upgrade paths | Upgrading Windows NT,2000 to Windows XP | Determine correct startup Utility (WINNT 32 Vs WINNT) | Application Compatibility | Apply service packs, patches and updates

Lesson 10: Boot Sequence

Boot Sequence | Boot steps for windows 9x system | Boot Steps for Windows NT/2000

Lesson 11: Alternative Boot Methods

Using a Startup disk | Safe mode/VGA mode | Last Known Good configuration | Command Prompt mode | Booting to a system restore point | Recovery console

Lesson 12: Creating Emergency Repair Disk (ERD)

Creating emergency repair disk (ERD)

Lesson 13: Post-assessment

Post-assessment

Lesson 14: Summary

01 of 01

Home \| Schools \| Contribute \| Contact Us \| Site Map		Copyright © 2005-2007 ProProfs.com